M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 19

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
(2) Target Status LEDs
The target status LEDs indicate the target MCU’s power supply and operating status. Table 1.3 lists the definition of each target status LED.
Table 1.3 Definitions of the target status LEDs
(3) System Reset Switch
By pressing the system reset switch, you can initialize the emulator system. Table 1.4 shows the functions of the system reset switch
depending on the state of the emulator.
Table 1.4 Functions of the system reset switch
(4) Power Connector (J1)
This is a connector for connecting the power supply to this product. For details, refer to “2.4 Connecting the Power Supply for the Emulator”
(page 24).
(5) USB Cable Connector (J2)
This is a USB cable connector for connecting the host machine to this product. For details, “2.5 Connecting the Host Machine” (page 25).
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
POWER
CLOCK
RESET
RUN
When the user’s program is halted
When the user’s program is executed
Notes on a System Reset:
Name
State of Emulator
After pressing the system reset switch, restart the emulator debugger. Otherwise the display of emulator debugger and the
actual value (in the emulator) may not match.
When the emulator debugger does not start up normally even after rebooting, turn off the emulator and then turn on again.
Number
LED3
LED4
LED5
LED6
Orange
Green
Green
Color
Red
Status
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Initializes the emulator and waits for a command from the
emulator debugger
Stops the user’s program, initializes the emulator, and waits for a
command from the emulator debugger.
Power is supplied to the target MCU.
Power is not supplied to the target MCU.
The target MCU internal clock is oscillating.
The target MCU internal clock is not oscillating.
Target MCU is being reset,
or reset signal of the user system is held low.
Target MCU is not being reset.
User program is being executed.
User program is not being executed.
IMPORTANT
Meaning
Function
Page 17 of 102
1. Outline