M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 26

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
2.3 Attaching the Ferrite Core
Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite core it may cause
interference.
The power cable should be wound around the ferrite core as shown in the figure, and close the ferrite core until it clicks.
Figure 2.2 Attaching the ferrite core
2.4 Connecting the Power Supply for the Emulator
Connect the power supply for the emulator to the power connector (J1). The specification of the power supply for the emulator
is listed in Table 2.1.
Table 2.1 Specification of power supply of the emulator
Figures 2.3 and 2.4 show the specifications of the power connector (J1) and an applicable plug, respectively.
Figure 2.3 Power connector specifications
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
Notes on Connecting a Power Supply of the Emulator:
Power supply voltage
Electrode (+)
The power cable included in this product package is colored red (+) and black (-).
Be careful about the polarity of the power supply. Connecting to the wrong electrode could destroy internal
circuits.
Do not apply a voltage exceeding the specified voltage of the product (5.0 V ±5%), because it may cause burn
injuries and the failure of internal circuits.
Use the power supply which complies with CE marking requirements.
DC 5.0 V±5％/2 A
Electrode (-)
Figure 2.4 Applicable plug specifications
CAUTION
ɸ 1.7mm(Inside diameter)
ɸ 4.75mm
Page 24 of 102
2. Setup