M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 28

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
2.6 Turning ON the Power
2.6.1 MCU Power Supply Source Selection Jumper/MCU Power Supply Voltage Selection Jumper
Set the MCU power supply source selection jumper and the MCU power supply voltage selection jumper of the emulator
according to conditions of use.
Figure 2.6 Jumper switch locations
These are the jumper switches to select power supply to the MCU and its power voltage. As shown in Table 2.2 below, set the
switch according to the connection to the user system.
Table 2.2 Setting jumper switches
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
Note on Jumper Switch Settings:
the user system
Not connected
Connection to
Connected
Always shut OFF the emulator before changing the setting of the jumper switches, and connecting the cable.
Otherwise the internal circuit may cause a break.
When the MCU power supply source selection jumper and MCU power supply voltage selection jumper are set
to INT and 5.0 V respectively, the selection jumper JP1 on the M30850T2-EPBM must be set as VCC1=2 side.
LED1
POWER
POWER
CLOCK
RESET
SAFE
RUN
LED3
LED6
LED2
COMPACT EMULATOR
MCU power supply
POWER
SAFE
POWER
CLOCK
RESET
RUN
source selection
jumper (JP1)
EXT
INT
STATUS
SYSTEM
TARGET
STATUS
COMPACT EMULATOR
M30850T3-CPE
MADE IN JAPAN
MADE
MCU power supply
voltage selection
POWER USB
5.0V
jumper (JP2)
Invalid
3.3 V
5.0 V
CAUTION
EXT
JP1
JP2
5.0V
3.3V
INT
Supplied from the emulator. The MCU operating
voltage is 3.3 V.
Supplied from the emulator. The MCU operating
voltage is 5.0 V.
Supplied from the user system. This emulator
consumes max. 500 mA of electrical current from the
user system.
SW1
JP1：MCU power supply source
JP2：MCU power supply voltage
(factory-setting: INT)
selection jumper
selection jumper
(factory-setting: 5.0V)
Description
Page 26 of 102
2. Setup