M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 30

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
2.6.5 LED Display When the Emulator Starts Up Normally
After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to “5. Troubleshooting” (page 93).
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
When the user system NOT connected:
The POWER LED does not light
System status LEDs
Target status LEDs
: OFF
: ON
POWER
POWER
CLOCK
RESET
LED1
SAFE
POWER
RUN
CLOCK
RESET
COMPACT EMULATOR
LED2
LED3
LED6
RUN
POWER
SAFE
POWER
CLOCK
RESET
RUN
(Power-on)
SYSTEM
STATUS
STATUS
COMPACT EMULATOR
TARGE
M30850T3-CPE
MADE IN JAPAN
LED3
LED5
T
LED4
LED6
MADE
POWER USB
J1
5.0V
(Emulator debugger started-up)
POWER
CLOCK
RESET
RUN
J2
JP2
EXT
JP1
5.0V
3.3V
INT
SW1
LED3
LED4
LED5
LED6
Page 28 of 102
2. Setup