M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 82

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
Note on Differences between the Actual MCU and Emulator:
Note on RESET# Input:
Note on RDY# Input:
Note on HOLD# Input:
Note on NMI# Input:
Operations of the emulator system differ from those of actual MCUs as listed below.
A low input to pin RESET# from the user system is accepted only when a user program is being executed
(when the RUN status LED on the emulator's upper panel is lit).
Be sure to input "L" to pin RDY# of the user system when a user program is being executed (when the RUN
status LED on the emulator’s upper panel is lit). Inputting "L" to pin RDY# during the user program stopping
may cause a malfunction of the emulator.
Be sure to input "L" to pin HOLD# of the user system when a user program is being executed (when the RUN
status LED on the emulator’s upper panel is lit). Inputting "L" to pin HOLD# during the user program stopping
may cause a malfunction of the emulator.
A low input to pin NMI# from the user system is accepted only when a user program is being executed (when
the RUN status LED on the emulator's upper panel is lit).
(1) Reset condition
(2) Initial values of internal resource data of an MCU at power-on
(3) Interrupt stack pointer (ISP) after a reset is released
(4) Capacities of the internal memories (ROM and RAM)
(5) Oscillator circuit
(6) A/D conversion
(7) Port P15
(8) XOUT pin
The MCU whose RAM size is 24 KB (400h--63FFh) is mounted on this product. The internal flash
memory is automatically allocated to F000h--FFFFh and F80000h--FFFFFFh in the single-chip mode and
memory expansion mode.
The characteristics of the A/D converter differ from those of actual MCU because there are a converter
board and other devices between the evaluation MCU and the user system.
As one of I/O ports (P15) is connected to the user system through the analog switch circuit, electric
characteristics slightly differ from those of an actual MCU.
When the SW4 is set to XOUT in stop mode, a clock is output from the XOUT pin.
- Make note of the fact that in the oscillator circuit where a resonator is connected between pins X
- For notes on when using the oscillator circuit on the user system, refer to "2.9.2 Selecting Clock
X
evaluation MCU and the user system. It is same for a sub-clock oscillator (X
Supply" (page 44).
OUT
, oscillation does not occur because a converter board and other devices are used between the
IMPORTANT
CIN
4. Hardware Specifications
and X
COUT
).
Page 80 of 102
IN
and