M30850T3-CPE Renesas Electronics America, M30850T3-CPE Datasheet - Page 24

• Manufacturer Part Number: M30850T3-CPE
• Description: EMULATOR FOR M32C/80,84,85,86,8A
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M30850T3-CPE

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32C/80, M32C/84, M32C/85, M32C/86, M32C/8A
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

M30850T3-CPE User’s Manual
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to “5. Troubleshooting” (page 93).
Figure 2.1 Flowchart of starting up the emulator
REJ10J1430-0300 Rev.3.00 Aug. 17, 2009
Connect the power supply for the emulator.
Debug a program with various functions of
Check the LED display of the emulator.
Connect the USB interface cable.
Install the included software etc.
Check the package components.
Start up the emulator debugger.
Set the operating environment
Turning on the power supply.
Set the MCU power voltage
of the emulator debugger.
Connect the user system.
selection jumper (JP2).
the emulator debugger.
User registration
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
↓
Refer to “1.1 Package Components” (page 14).
Refer to “User Registration” (page 12).
Install it from the included CD-ROM.
Select a power voltage supplied to the target MCU.
Connect the USB interface cable to the USB interface connector
(J2) of the emulator and the USB port of the host machine.
Connect a power supply to the power connector (J1). Power supply
should be 5.0 V ±5%, / 2 A.
Connect the user system as occasion demands.
Turn on the power to the emulator and the user system as
simultaneously as possible.
Check that the system status LED, and POWER and RESET of
target status LED are lighting. When the user system is not
connected, the POWER LED does not light up.
Start up the emulator debugger.
Set the INIT dialog box and EMEM dialog box of the emulator
debugger.
For how to use the emulator debugger, refer to its online manual.
Page 22 of 102
2. Setup