R0E0200F0EMU00 Renesas Electronics America, R0E0200F0EMU00 Datasheet - Page 409

• Manufacturer Part Number: R0E0200F0EMU00
• Description: EMULATOR E200 MAIN BODY-SH7780
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In-Circuit Emulatorr

Specifications of R0E0200F0EMU00

• Contents: Emulator Board, Cables, Software and Documentation
• For Use With/related Products: SH7780
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

9. Note on [Register] Window Operation During Program Execution
10. Break Function
11. Number of BREAKPOINT and [Stop At] Settings in the [Run...] Menu
12. Note on Displaying Timeout error
13. Note on Using the [Run Program] Dialog Box
14. BREAKPOINT Setting for SLEEP Instruction
15. Note on Session Save in the [Configuration] Dialog Box
The register value cannot be changed in the [Register] window during program execution.
Even if the changed value is displayed, the register contents are not changed actually.
⎯ BREAKPOINT cancellation
The maximum number of BREAKPOINTs and [Stop At] settings allowed in the [Run...] menu
is 1000. Therefore, when 1000 BREAKPOINTs are set, specification by [Stop At] in the
[Run...] menu becomes invalid. Use the BREAKPOINTs and [Stop At] in the [Run...] menu
with 1000 or less total settings.
If Timeout error is displayed, the emulator cannot communicate with the target
microcomputer. Turn off the user system and connect the USB connector of the emulator
again by using the High-performance Embedded Workshop.
When [Run...] is selected from the [Debug] menu to specify the stop address, there is the
following note:
⎯ When the breakpoint that has been set as Disable is specified as the stop address, note that
When a break is set for the SLEEP instruction, use the Break Condition not the
BREAKPOINT.
The following settings are not saved as a session:
⎯ JTAG clock in the [General] page
⎯ Loading flash memory in the [Loading flash memory] page
When the contents of the BREAKPOINT address is modified during user program
execution, the following message is displayed when the user program stops.
If the above message is displayed, cancel all BREAKPOINT settings with the [Delete All]
or [Disable] button in the [Eventpoint] window.
the breakpoint becomes Enable when the user program stops.
BREAKPOINT IS DELETED A=xxxxxxxx
383