R0E0200F0EMU00 Renesas Electronics America, R0E0200F0EMU00 Datasheet - Page 61

• Manufacturer Part Number: R0E0200F0EMU00
• Description: EMULATOR E200 MAIN BODY-SH7780
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: In-Circuit Emulatorr

Specifications of R0E0200F0EMU00

• Contents: Emulator Board, Cables, Software and Documentation
• For Use With/related Products: SH7780
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1.3.4 Break Function
The emulator has the following seven break functions.
(1) PC break function (BREAKPOINT)
(2) On-chip event break function
Note: On-chip event break settings can be changed during user program execution.
(3) AUD event break function
(4) External bus event break function
(5) Other event break functions
Breaks the program at the specified address by replacing the dedicated instruction onto the
original instruction. This function cannot be set at a place other than RAM since a memory
write occurs.
This function can be set in the [Breakpoint] sheet of the [Event] window. It can also be set in
the [Source] or [Disassembly] window by double-clicking on the line to be set in the [S/W
breakpoint] column.
Breaks when the specified event has been detected by the on-chip event detection function.
This function is available when the operation after detecting an event is set as ‘break’ in the
[Onchip Event] sheet of the [Event] window.
It can also be set in the [Source] or [Disassembly] window by double-clicking on the line to be
set in the [Onchip event] column.
Breaks when the specified event has been detected by the AUD event detection function.
This function is available when the operation after detecting an event is set as ‘break’ in the
[AUD Event] sheet of the [Event] window.
It can also be set in the [Source] or [Disassembly] window by double-clicking on the line to be
set in the [AUD Event] column.
Breaks when the specified event has been detected by the external bus event detection
function.
This function is available when the operation after detecting an event is set as ‘break’ in the
[BUS Event] sheet of the [Event] window.
It can also be set in the [Source] or [Disassembly] window by double-clicking on the line to be
set in the [BUS Event] column.
⎯ Execution time event detection function
⎯ External probe event detection function
35