HS7046EPH60H Renesas Electronics America, HS7046EPH60H Datasheet - Page 139

• Manufacturer Part Number: HS7046EPH60H
• Description: DEV EMULATOR BASE SH7046
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: Microcontrollerr

Specifications of HS7046EPH60H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: SH7046
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

(1) [Condition] page
[Sequential Trace Stop]: Use this option to set a sequential trace stop by using channels 1 to 7. The sequential
[Run time count between trigger outputs]:
[Free trace]:
[Back]:
Figure 3.27 [Trace Acquisition Properties] Dialog Box ([Condition] Page)
trace stop function allows trace acquisition to stop when the conditions of several
channels are satisfied in the specified order. Two to seven pass points and one reset
point are selectable as sequential trace stop conditions. The conditions are satisfied in
the order of 1 to 7. To use a sequential trace stop, select the checkbox of the channel.
To set a reset condition, select the [Reset Point] checkbox. Channel 8 is used for a
reset condition. When a reset condition is satisfied, all the sequential trace stop
conditions that have been satisfied will be cleared and the emulator starts checking
the first condition again. When a sequential trace stop is enabled, no setting is
available for the channels (out of 1 to 7) that are not used for the sequential trace stop
function.
Selects channels for use in execution time measurement. Clicking [Use] allows
measurement of time in tracing. There are four types of channel combinations
consisted of those for the start and the end of measurement: 1-2, 3-4, 5-6, and 7-8.
Selects the free trace mode. When [Free trace] is enabled, any trace acquisition
condition set will be ignored.
Puts the setting back to the previous state at the time the dialog box has been
displayed.
51