HS7046EPH60H Renesas Electronics America, HS7046EPH60H Datasheet - Page 232

• Manufacturer Part Number: HS7046EPH60H
• Description: DEV EMULATOR BASE SH7046
• Manufacturer: Renesas Electronics America
• Series: SuperH®r
• Type: Microcontrollerr

Specifications of HS7046EPH60H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: SH7046
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Table 6.1 Error Messages at Initiation
Error Message
There is no configuration file.
The contents of the configuration file
are incorrect.
Main Board not Support (XX XX XX)
Emulator is switched off or not
connected
Emulation Board not Support
(XX XX XX)
Emulator is switched off or not
connected
EVA chip Board not Support
(XX XX XX)
Emulator is switched off or not
connected
Can’t initialize G/A registers
There is no effective clock source
This mode can not specify
144
Description and Solution
The configuration file that is required to initiate the emulator
cannot be found. Exit and re-install the High-performance
Embedded Workshop. Then re-connect the user system
interface cable, turn on the power of the emulator, and re-
initiate the High-performance Embedded Workshop. If the
problem is not solved, contact us and describe the error
occurrence in detail.
The configuration file that is required to initiate the emulator
is invalid. Exit and re-install the High-performance Embedded
Workshop. Then re-connect the user system interface cable,
turn on the power of the emulator, and re-initiate the High-
performance Embedded Workshop. If the problem is not
solved, contact us and describe the error occurrence in
detail.
The emulator power is not turned on, or the user system
interface cable is not connected. Exit the High-performance
Embedded Workshop, re-connect the user system interface
cable, turn on the power of the emulator, and re-initiate the
High-performance Embedded Workshop. If the problem is
not solved, contact us and describe the error occurrence in
detail.
The emulator power is not turned on, or the user system
interface cable is not connected. Exit the High-performance
Embedded Workshop, re-connect the user system interface
cable, turn on the power of the emulator, and re-initiate the
High-performance Embedded Workshop. If the problem is
not solved, contact us and describe the error occurrence in
detail.
The emulator power is not turned on, or the user system
interface cable is not connected. Exit the High-performance
Embedded Workshop, re-connect the user system interface
cable, turn on the power of the emulator, and re-initiate the
High-performance Embedded Workshop. If the problem is
not solved, contact us and describe the error occurrence in
detail.
An error occurred during the initialization of the emulator. Exit
the High-performance Embedded Workshop, re-connect the
user system interface cable, turn on the power of the
emulator, and re-initiate the High-performance Embedded
Workshop. If the problem is not solved, contact us and
describe the error occurrence in detail.
A valid clock source cannot be found. Connect a valid clock
source.
The state of mode pins for the target board is incorrect.
Initiation is only possible in mode 4. Set the mode pins
correctly.