PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 111

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
(4) Connection of program adapter
(5) Startup of programming GUI
<4> Refer to CHAPTER 3 SOFTWARE INSTALLATION and install the USB driver (in case Found New Hardware
<1> Connect the FP5 GND connector to the program adapter using a GND cable.
Caution
<2> Connect the FP5 target connector to the program adapter using the target cable.
Be sure to turn on the FP5 power before connecting the program adapter or target system.
Remark
<1> Click the Start menu, “All Programs”, point to “NEC Electronics Tools”, “Latest Version”, and then select
in the message display, indicating that the FP5 is ready for operation. If not, the cause may be a defect in the
FP5, so consult a Renesas Electronics sales representative or distributor.
Wizard is started by Plug and Play).
“PG-FP5 Vx.xx” to start the Programming GUI.
detected in the order of the USB, and then the serial interface.
The FP5 and target system may be damaged if the voltage between the FP5 GND and the target
system GND is different. Use the GND cable to match the voltage before connecting the target
cable.
Connect the target system before supplying V
Figure 5-1. Connection Between Programming GUI and FP5
CHAPTER 5 EXAMPLE OF OPERATION USING PROGRAMMING GUI
DD
/V
The valid communication modes are automatically
DD2
power from the target system.
Page 111 of 240