PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 189

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
cable characteristics should be equivalent or higher than those of the supplied cable.
communication errors may occur and causing abnormal operation.
9.5
9.5.1
banana jack and a spade terminal.
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
Remark The following are the recommended connectors to be connected to 16-pin 2.54 mm pitch multipurpose female
When using a self-made cable because the supplied cable cannot be used due to the target system specifications, the
Note that communication may be performed at high speed depending on the communication settings. Consequently,
The banana jack GND connector is laid out on the target connector side of the FP5.
Remark Part number of GND connector (banana jack): PB4 (HIRSCHMANN)
The host cable is a standard shielded GND cable approximately 1 meter long. The GND cable is equipped with a
Caution The FP5 and target system may be damaged if the voltage between the FP5 GND and the target
Remark Part number of banana jack: TJ-2167 (made by Sato Parts Co., Ltd.)
GND Connector
GND cable
Part number of spade terminal: BPF1.25-3 (red) (Daido Solderless Terminals Mfg. Co., Ltd.)
connectors.
• HIF3FC-16PA-2.54DS (made by Hirose Electric Co., Ltd., right angle type)
• HIF3FC-16PA-2.54DSA (made by Hirose Electric Co., Ltd., straight type)
• 7616-5002PL (Sumitomo 3M Limited, right angle type)
• 7616-6002PL (Sumitomo 3M Limited, straight type)
system GND is different. Use the GND cable to match the voltage before connecting the target cable.
Banana Jack
Figure 9-13. GND Connector <FP5 Target Connector Side>
Figure 9-14. GND Cable Outline
GND connector
CHAPTER 9 CONNECTORS AND CABLES
Spade terminal
Page 189 of 240