PG-FP5-EA Renesas Electronics America, PG-FP5-EA Datasheet - Page 209

• Manufacturer Part Number: PG-FP5-EA
• Description: PROGRAMMER FLASH MEMORY UNIV
• Manufacturer: Renesas Electronics America

Specifications of PG-FP5-EA

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PG-FP5
A.3 Information Dialog Boxes for Programming GUI Operation
R20UT0008EJ0400 Rev. 4.00
Jul 15, 2010
I 2100
I 2200
I 2201
I 2202
I 2203
I 2204
I 2207
I 2208
I 2209
I 2210
No.
Please setup host connection again.
Please open 'Setup' form menu. It will help you down load
parameter & setting files
Parameter/setting files are not matched.
Parameter/setting files are not find.
Are you sure, you want to update the Firmware?
Are you sure, you want to update the FPGA?
Do you really want change parameter area format? All data
will lost after this action
Information defined in initial file is not enough or it is not
matched with FlashProgrammer. Setup parameters is
needed.
Information defined in initial file is not complete matched
with FlashProgrammer. Do you want to go Setup dialog?
Updating the firmware will take several minutes.
ATTENTION:
-The process of updating your firmware must NOT be
interrupted! --Without firmware this FP5 GUI will NOT run
properly.
Install new firmware in your programmer?
Message
After FP5 reset, communication with FP5 was attempted
but failed. Try [Programmer] - [Setup host connection] in
the menu.
Open [Setup] in the menu and then download the PR5 or
ESF file.
Information does not match the one defined in the PR5/ESF
file.
The cause may be the following:
1. The PR5 or ESF file, which is defined in the INI file, is
2. Information on the PR5 or ESF file is missing in the INI
3. No PR5 or ESF file is stored in the FP5, but valid PR5 or
The PR5 or ESF file is missing.
No valid PR5 or ESF file is defined in the INI file.
Store a valid PR5 or ESF file in installation-folder\FP5_PRJ.
Select whether to update the firmware.
Click 'Ok' to update the firmware. Click Cancel to cancel the
operation.
Select whether to update the FPGA.
Click 'Ok' to update the FPGA. Click Cancel to cancel the
operation.
Select whether to change the factor for dividing the
programming area. After this operation, all data will be lost.
The settings in the ESF file are insufficient or do not match
the settings made in the FP5. Device setup is required.
The contents of the ESF file do not match those stored in
the FP5. Select whether to open the Device Setup dialog
box.
The firmware update will take several minutes.
ATTENTION:
Firmware update cannot be aborted. The FP5 may not
operate normally if proper firmware is not installed.
Select whether to update the firmware.
different from the one stored in the FP5.
file, but a valid PR5 or ESF file is stored in the FP5.
ESF file has been detected because they are defined in
the INI file.
Description
APPENDIX A MESSAGES
Page 209 of 240
(1/3)