MCB2100+U NXP Semiconductors, MCB2100+U Datasheet - Page 10

• Manufacturer Part Number: MCB2100+U
• Description: BOARD EVAL/ULINK JTAG LPC210XARM
• Manufacturer: NXP Semiconductors
• Series: Keilr
• Type: ARM7 Processor, Microcontrollerr

Specifications of MCB2100+U

• Contents: Evaluation Board, ULINK JTAG, Debugger and Software
• For Use With/related Products: LPC2114,2119,2124,2129,2194
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 568-1755; OM10046

NXP Semiconductors
AN10302_4
Application note
4.1.1 Enabling ISP mode with the MCB2100
4.2 The IAR/Philips LPC210x Kickstart card
LEDs — buffered with a 74LVC octal buffer, enabled by J6.
Potentiometer — Configured as a voltage divider with its output connected to AIN0 via
jumper J2.
Table 1.
[1]
[2]
The Keil MCB2100 evaluation board was designed to utilize the RTS/DTR control of reset
and P0.14 as featured in the Philips LPC2000 Flash utility.
To setup the MCB2100 for ISP programming set the jumpers: J1, J3, J4, J5, J7 and J10.
Connect the PC serial port to COM0 of the MCB2100 and start the LPC2000 Flash Utility.
Check the “Use DTR/RTS……” box and continue.
This evaluation board is populated with an LPC2106 microcontroller and features 2 serial
ports, 2 user-defined buttons, 16 fully configurable LEDs, 20-pin JTAG interface connector
as well as breakout headers for all pins.
Jumper
J1
J2
J3
J4
J5
J6
J7
J8
J9
J10
[1]
[1]
[2]
These jumpers supply the voltages to the microcontroller and must be in for normal operation.
Remove this jumper when not using ISP.
Keil MCB2100 jumper functions
Function
Configures P0.14 for DTR/RTS control of ISP (see ISP section below)
Potentiometer/ADC Connect
3.3 V enable
1.8 V enable
3.3 V analog voltage supply enable
LED enable
Configures P0.14 for external interrupt or manual ISP entry
ETM Pins Enable (Pulls TraceSync LOW)
JTAG Debug Pins Enable (Pulls RTCK LOW)
Configures RESET for DTR/RTS control of ISP (see ISP section below)
Rev. 04 — 12 October 2006
Using the Philips LPC2000 Flash utility
AN10302
© NXP B.V. 2006. All rights reserved.
10 of 14