863 B&K Precision, 863 Datasheet - Page 123

• Manufacturer Part Number: 863
• Description: PROGRAMMER SER EPROM +150MCNTRLR
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 863

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: Serial EEPROM and Microchip PICmicro Microcontrollers
• Other names: BK863

Options / Handler
Speed - sets speed, if a manual establishing communication is
selected, which PC sends data into the programmer. Speed is
expressed as a percent from a maximal speed.
The communication speed modification is important for PCs
with "slow" LPT ports, which haven't sufficient driving power for
a PC<->programmer cable (laptop, notebook, ...). Use this
command, if you have any communication problems with
connected programmer on the LPT port of your PC (e.g.
control
communication with the programmer is unreliable, etc.).
If automatic establishing communication is selected, then
control program sets a maximal communication speed.
Port - selects a LPT port, which will be scanned for a
requested programmer. If All port is selected, the control
program scans all LPT ports, which are available on standard
addresses.
Address for special port - sets address of LPT port, if a
Special port is selected.
Pressing key <Enter> or button OK initiates scanning for
programmer by set parameters. There is same activity as at
start the control program. The command clears a list of default
devices without the current device, if the new selected
programmer supports this one.
This setting is saved to disk by command Options / Save
options.
In dialog Handler a Handler type and Handler communication
parameters can be set. Handler is an external device for
special control of device operations in control program. When
None Handler is selected, this means default state of control
program, i.e. device operations are controlled directly by user
otherwise control program is in special mode, when device
operations are controlled automatically with co-operation with
Handler.
Dialog Handler contains following items:
Selected Handler
Search at port
for a requested Handler.
Pressing key <Enter> or button OK initiates scanning for
Handler by set parameters. If selected Handler type is None,
no Handler scanning will be processed. Current Handler
program
reports
select wished Handler type.
select a COM port, which will be scanned
123
a
programmer
absence,
Software
the