863 B&K Precision, 863 Datasheet - Page 135
863
Manufacturer Part Number
863
Description
PROGRAMMER SER EPROM +150MCNTRLR
Manufacturer
B&K Precision
Type
Universalr
Datasheet
1.863.pdf
(151 pages)
Specifications of 863
Contents
Programmer, Adapter, Cable, Manual and Software
For Use With/related Products
Serial EEPROM and Microchip PICmicro Microcontrollers
Other names
BK863
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
8630-2M
Manufacturer:
ATMEL
Quantity:
1 350
Part Number:
8630-2M
Manufacturer:
NA
Quantity:
20 000
Company:
Part Number:
863001
Manufacturer:
Amphenol FCI
Quantity:
900
Company:
Part Number:
863001017
Manufacturer:
Amphenol FCI
Quantity:
200
Company:
Part Number:
863001017TLF
Manufacturer:
Amphenol FCI
Quantity:
1 667
Company:
Part Number:
863001018TLF
Manufacturer:
Amphenol FCI
Quantity:
1 477
The recommended ISP interface connector
layout in target system
1. Turn off both devices – ISP programmer and target device.
2. Assign same GND potential for all devices, e.g. connect GND
3. Insert one connector of ISP cable to ISP programmer, turn on
4. In control program select target device and operation options.
5. Start action on target device (read, program).
6. After direction of control program, connect other ISP cable
7. After direction of control program, disconnect other ISP cable
8. If you need another action on target device, you continue with
Note: When you don’t keep below directions and you damage
programmer during in-system programming, it is damage of
programmer by unqualified manipulation and is out of warranty.
For in-system programmable devices manufacturers publish
applications notes. Allocations notes, which B+K PRECISION
use
www.bkprecision.com
Example of application note
This application note is used in 849. This interface corresponds
with Atmel application note AVR910: In-System Programming.
This application note describes the recommended ISP
interface connector layout in target system (top view).
of all devices by wire.
programmer and control program.
connector to target system and turn on it.
connector from target system and turn off it.
step 5.
Note:
If target system use signals needed for ISP programming, it’s
necessary separate then from target device by appropriate
resistors.
in
ISP
MISO
SCK
RESET
programmers
, section download.
3
5
1
135
2
4
6
MOSI
GND
Vcc
are
published
in