863 B&K Precision, 863 Datasheet - Page 23

no-image

863

Manufacturer Part Number
863
Description
PROGRAMMER SER EPROM +150MCNTRLR
Manufacturer
B&K Precision
Type
Universalr
Datasheet

Specifications of 863

Contents
Programmer, Adapter, Cable, Manual and Software
For Use With/related Products
Serial EEPROM and Microchip PICmicro Microcontrollers
Other names
BK863

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
8630-2M
Manufacturer:
ATMEL
Quantity:
1 350
Part Number:
8630-2M
Manufacturer:
NA
Quantity:
20 000
Part Number:
863001
Manufacturer:
Amphenol FCI
Quantity:
900
Part Number:
863001017
Manufacturer:
Amphenol FCI
Quantity:
200
Part Number:
863001017TLF
Manufacturer:
Amphenol FCI
Quantity:
1 667
Part Number:
863001018TLF
Manufacturer:
Amphenol FCI
Quantity:
1 477
Connecting 865 to the PC
Switch off PC and programmer. Insert the communication
cable included with your 865 programmer package to a free
printer port on your PC. If your computer is equipped with only
one printer port, substitute the programmer cable for the printer
cable. Connect the opposite cable end to the programmer.
Screw on both connectors to counter-connectors. This is very
important. It may be uncomfortable to switch between printer
cable and programmer cable, though it is not recommended to
operate the 865 programmer through a mechanical printer
switch. Use of an electronic printer switch is impossible. But
you can install a second multi-I/O in your computer, thus
obtaining a supplementary printer port, says LPT2. So your
printer may remain on LPT1 while the programmer on LPT2.
Switch on the PC.
Connect the mains connector of the power supply (or the wall-
plug power supply itself) to a mains plug, and then connect the
mini-DIN connector to the programmer's connector labeled
"12VAC". At this time all 'work result' LEDs (and 'POWER'
LED) light up successive and then switch off. Once the
POWER LED lights with low brightness then the 865
programmer is ready to run.
Next run the control program for 865.
Caution! If you don't want to switch off your PC when
connecting the 865, proceed as follows:
• When connecting the programmer to the PC: FIRST insert
• When disconnecting the programmer from the PC: FIRST
From 865's point of view the connecting and disconnecting
sequence is irrelevant. Protection circuits on all programmer
inputs keep it safe. But think of your PC please.
Note: Programmer's protection electronics protect the target
device and the programmer itself against either short or long-
term power failures and, partly, also against a PC failure.
However, it is not possible to grant the integrity of the target
device
parameters. Target device may be not destroyed by forced
interruption of the control program (reset or switch-off PC), by
removing the physical connection to the programmer, but the
content of actually programmed cell may remains undefined.
Don't unplug the target device from the ZIF socket during work
with devices (LED BUSY shine).
the communications cable and THEN the power-supply
connector.
disconnect the power-supply connector and THEN the
communication cable.
due
to
incorrect,
23
user-selected
programming

Related parts for 863