863 B&K Precision, 863 Datasheet - Page 26

• Manufacturer Part Number: 863
• Description: PROGRAMMER SER EPROM +150MCNTRLR
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 863

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: Serial EEPROM and Microchip PICmicro Microcontrollers
• Other names: BK863

Technical specification
HARDWARE
Base unit, DACs
Socket, pindriver
Socket, base configuration
DEVICE SUPPORT
Programmer
• FPGA based IEEE 1284 slave printer port, up to 1MB/s
• on-board powerful microprocessor (20MHz) supported by
• three D/A converters for VCCP, VPP1, and VPP2,
• VCCP range 0..8V/1A
• VPP1, VPP2 range 0..26V/1A
• auto calibration
• self test capability
• protection against surge and ESD on power supply input,
• banana jack for ESD wrist straps
• pin drivers: 48 as standard, max. 256
• 1x VCC, 2x VPP can be connected to each pin
• perfect ground for each pin
• FPGA based TTL driver provides H, L, CLK, pull-up, pull-
• analog pindriver output level selectable from 1.8 V up to 26V
• current limitation, over current shutdown, power failure
• ESD protection on each pin of socket (IEC1000-4-2: 15kV air,
• continuity test: each pin is tested before every programming
• 48-pin DIL ZIF (Zero Insertion Force) socket accepts both
• EPROM: NMOS/CMOS, 1702*, 2708*, 27xxx and 27Cxxx
• EEPROM: NMOS/CMOS, 28xxx, 28Cxxx, 27EExxx series,
transfer rate
FPGA based state machine, 20MHz powered
controllable rise and fall time
parallel port connection
down on all pindriver pins
shutdown
8kV contact)
operation
300/600 mil devices up to 48-pin
series, with 8/16 bit data width, full support for LV series
with 8/16 bit data width
26