863 B&K Precision, 863 Datasheet - Page 59

• Manufacturer Part Number: 863
• Description: PROGRAMMER SER EPROM +150MCNTRLR
• Manufacturer: B&K Precision
• Type: Universalr

Specifications of 863

• Contents: Programmer, Adapter, Cable, Manual and Software
• For Use With/related Products: Serial EEPROM and Microchip PICmicro Microcontrollers
• Other names: BK863

Connecting 848 programmer to
PC
Problems
interconnection, and their removing
Switch off the PC and programmer. Insert the connection
cable, included in the 848 programmer delivery, to the free
printer port of PC. If your computer is equipped with only one
printer port, substitute the programmer cable for the printer
cable. Connect the opposite cable end to the programmer.
Screw on both connectors to counter connectors. This is very
important mainly for the connector to programmer. Though
replacing the printer cable by the programmer cable is
uncomfortable, it is not recommended to operate the 848
programmer through a mechanical printer switch. Use of an
electronic printer switch isn't possible.
Connect the mains connector of the power supply (or wall-plug
power supply self) to a mains plug, connect the connector to
the programmer's connector labeled 12VDC. Then, on the
programmer lights up LED POWER and the programmer 848
is ready to run. Next switch on the PC and run the control
program.
Caution! If you don't want to switch off your PC when
connecting the 848, proceed as follows:
• When connecting the programmer to the PC: FIRST insert
• When disconnecting the programmer from the PC: FIRST
If you have any problems with 848 ) PC interconnection,
see section Common notes please.
the communications cable and THEN the power-supply
connector.
disconnect the power-supply connector and THEN the
communication cable.
related
59
to
the
848
)
PC