HD6417708SF60V Renesas Electronics America, HD6417708SF60V Datasheet - Page 373

• Manufacturer Part Number: HD6417708SF60V
• Description: IC SUPERH MPU ROMLESS 208LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417708SF60V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 60MHz
• Connectivity: EBI/EMI, SCI, SmartCard
• Peripherals: POR, WDT
• Number Of I /o: 8
• Program Memory Type: ROMless
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Ram Size: -
• Program Memory Size: -
• Data Converters: -

Bit 4—Framing Error (FER): Indicates that data reception aborted due to a framing error in
asynchronous mode.
Bit 4: FER
0
1
Bit 3—Parity Error (PER): Indicates that data reception (with parity) aborted due to a parity error
in asynchronous mode.
Bit 3: PER
0
1
Description
Receiving is in progress or has ended normally.
Clearing the RE bit to 0 in the serial control register does not affect the FER bit,
which retains its previous value.
FER is cleared to 0 when the chip is reset or enters standby mode or software
reads FER after it has been set to 1, then writes 0 in FER.
A receive framing error occurred.
When the stop bit length is two bits, only the first bit is checked. The second stop
bit is not checked. When a framing error occurs, the SCI transfers the receive
data into SCRDR but does not set RDRF. Serial receiving cannot continue while
FER is set to 1. In synchronous mode, serial transmitting is also disabled.
FER is set to 1 if the stop bit at the end of receive data is checked and found to
be 0.
Description
Receiving is in progress or has ended normally.
Clearing the RE bit to 0 in the serial control register does not affect the PER bit,
which retains its previous value.
PER is cleared to 0 when the chip is reset or enters standby mode or software
reads PER after it has been set to 1, then writes 0 in PER.
A receive parity error occurred.
When a parity error occurs, the SCI transfers the receive data into SCRDR but
does not set RDRF. Serial receiving cannot continue while PER is set to 1. In
synchronous mode, serial transmitting is also disabled.
PER is set to 1 if the number of 1s in receive data, including the parity bit, does
not match the even or odd parity setting of the parity mode bit (O/E) in the serial
mode register (SCSMR).
(Initial value)
(Initial value)
353