Z8F6401VN020SC00TR Zilog, Z8F6401VN020SC00TR Datasheet - Page 77

• Manufacturer Part Number: Z8F6401VN020SC00TR
• Description: IC ENCORE MCU FLASH 64K 44PLCC
• Manufacturer: Zilog
• Series: Encore!®r

Specifications of Z8F6401VN020SC00TR

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 44-LCC (J-Lead)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: Z8F6401VN020SC00T

PS017610-0404
One-Shot Mode Time-Out Period (s)
out, first set the TPOL bit in the Timer Control Register to the start value before beginning
One-Shot mode. Then, after starting the timer, set TPOL to the opposite bit value.
The steps for configuring a timer for One-Shot mode and initiating the count are as fol-
lows:
1. Write to the Timer Control register to:
2. Write to the Timer High and Low Byte registers to set the starting count value.
3. Write to the Timer Reload High and Low Byte registers to set the Reload value.
4. If desired, enable the timer interrupt and set the timer interrupt priority by writing to
5. If using the Timer Output function, configure the associated GPIO port pin for the
6. Write to the Timer Control register to enable the timer and initiate counting.
In One-Shot mode, the system clock always provides the timer input. The timer period is
given by the following equation:
Continuous Mode
In Continuous mode, the timer counts up to the 16-bit Reload value stored in the Timer
Reload High and Low Byte registers. The timer input is the system clock. Upon reaching
the Reload value, the timer generates an interrupt, the count value in the Timer High and
Low Byte registers is reset to
alternate function is enabled, the Timer Output pin changes state (from Low to High or
from High to Low) upon timer Reload.
The steps for configuring a timer for Continuous mode and initiating the count are as fol-
lows:
1. Write to the Timer Control register to:
–
–
–
–
the relevant interrupt registers.
Timer Output alternate function.
–
–
–
Disable the timer
Configure the timer for One-Shot mode.
Set the prescale value.
If using the Timer Output alternate function, set the initial output level (High or
Low).
Disable the timer
Configure the timer for Continuous mode.
Set the prescale value.
0001H
Z8F640x/Z8F480x/Z8F320x/Z8F240x/Z8F160x
and counting resumes. Also, if the Timer Output
=
(
----------------------------------------------------------------------------------------------------- -
Reload Value Start Value
System Clock Frequency (Hz)
–
)
×
Z8 Encore!
Prescale
Timers
®
59