CV500ETN01 Omron, CV500ETN01 Datasheet - Page 24

• Manufacturer Part Number: CV500ETN01
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500ETN01

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6
6-1
6-2
Conformance to EC Directives
Conformance to EC Directives
Applicable Directives
Concepts
Note
EMC Directives
OMRON devices that comply with EC Directives also conform to the related
EMC standards so that they can be more easily built into other devices or the
overall machine. The actual products have been checked for conformity to
EMC standards (see the following note). Whether the products conform to the
standards in the system used by the customer, however, must be checked by
the customer.
EMC-related performance of the OMRON devices that comply with EC Direc-
tives will vary depending on the configuration, wiring, and other conditions of
the equipment or control panel on which the OMRON devices are installed.
The customer must, therefore, perform the final check to confirm that devices
and the overall machine conform to EMC standards.
Applicable EMS (Electromagnetic Susceptibility) and EMI (Electromagnetic
Interference) Standards in the EMC (Electromagnetic Compatibility) stan-
dards are as follows:
CS1W-ETN21
CJ1W-ETN21
• Check the user program for proper execution before actually running it on
• Observe the following precautions when wiring the communications
• Before touching a Unit, be sure to first touch a grounded metallic object in
• Confirm that no adverse effect will occur in the system before attempting
• EMC Directives
• Low Voltage Directive
the Unit. Not checking the program may result in unexpected operation.
cable.
order to discharge any static build-up. Not doing so may result in malfunc-
tion or damage.
any of the following. Not doing so may result in an unexpected operation.
Unit/Board
• Separate the communications cables from the power lines or high-ten-
• Do not bend the communications cables past their natural bending ra-
• Do not pull on the communications cables.
• Do not place heavy objects on top of the communications cables.
• Always lay communications cable inside ducts.
• Use appropriate communications cables.
• Changing the operating mode of the PLC (including the setting of the
• Force-setting/force-resetting any bit in memory.
• Changing the present value of any word or any set value in memory.
sion lines.
dius.
startup operation mode).
EN61000-6-2
EMS
EN61000-6-4
(Radiated emission: 10-m
regulations)
EMI
xxv
6