M29DW128G70NF6E

Manufacturer Part NumberM29DW128G70NF6E
DescriptionP7ED TSOP56 DUAL BANK
ManufacturerNUMONYX
M29DW128G70NF6E datasheet
 


1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
Page 31
32
Page 32
33
Page 33
34
Page 34
35
Page 35
36
Page 36
37
Page 37
38
Page 38
39
Page 39
40
Page 40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
Page 38/85

Download datasheet (2Mb)Embed
PrevNext
Command interface
Once password program operation has completed, an Exit Protection Command Set
command must be issued to return the device to read mode. The password protection mode
can then be selected.
By default, all password bits are set to ‘1’.
Password Read command
The Password Read command is used to verify the password used in password protection
mode.
To verify the 64-bit password, the complete command sequence must be entered four times
at four consecutive addresses selected by A1-A0.
If the password mode lock bit is programmed and the user attempts to read the password,
the device will output FFh onto the I/O data bus.
An Exit Protection Command Set command must be issued to return the device to read
mode.
Password Unlock command
The Password Unlock command is used to clear the NVPB lock bit allowing to modify the
NVPBs.
The Password Unlock command must be issued along with the correct password.
There must be a 1 µs delay between successive password unlock commands in order to
prevent hackers from cracking the password by trying all possible 64-bit combinations. If this
delay is not respected, the latest command will be ignored.
Approximately 1 µs is required for unlocking the device after the valid 64-bit password has
been provided.
7.3.5
Non-volatile protection mode command set
Enter Non-volatile Protection Command Set command
Three bus write cycles are required to issue the Enter Non-volatile Protection Command Set
command. Once the command has been issued, the commands related to the non-volatile
protection mode can be issued to the device.
Non-volatile Protection Bit Program command (NVPB Program)
A block can be protected from program or erase by issuing a Non-volatile Protection Bit
command along with the block address. This command sets the NVPB to ‘1’ for a given
block.
Read Non-volatile Protection Bit Status command (Read NVPB Status)
The status of a NVPB for a given block or group of blocks can be read by issuing a Read
Non-Volatile Modify Protection Bit command along with the block address.
Clear all Non-volatile Protection Bits command (Clear all NVPBs)
The NVPBs are erased simultaneously by issuing a Clear all Non-volatile Protection Bits
command. No specific block address is required. If the NVPB lock bit is set to ‘0’, the
command fails.
38/85
M29DW128G