AD9514BCPZ Analog Devices Inc, AD9514BCPZ Datasheet - Page 24

• Manufacturer Part Number: AD9514BCPZ
• Description: IC CLOCK DIST 3OUT PLL 32LFCSP
• Manufacturer: Analog Devices Inc
• Type: Fanout Buffer (Distribution), Dividerr

Specifications of AD9514BCPZ

• Number Of Circuits: 1
• Ratio - Input:output: 1:3
• Differential - Input:output: Yes/Yes
• Input: Differential
• Output: CMOS, LVDS, LVPECL
• Frequency - Max: 1.6GHz
• Voltage - Supply: 3.135 V ~ 3.465 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 32-LFCSP
• Frequency-max: 1.6GHz
• No. Of Multipliers / Dividers: 3
• No. Of Amplifiers: 4
• Supply Voltage Range: 3.135V To 3.465V
• Slew Rate: 1V/ns
• Operating Temperature Range: -40°C To +85°C
• Digital Ic Case Style: LFCSP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: AD9514/PCBZ - BOARD EVAL CLOCK 3CH AD9514
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

AD9514
Exposed Metal Paddle
The exposed metal paddle on the AD9514 package is an
electrical connection, as well as a thermal enhancement. For the
device to function properly, the paddle must be properly
attached to ground (GND).
The exposed paddle of the AD9514 package must be soldered
down. The AD9514 must dissipate heat through its exposed
paddle. The PCB acts as a heat sink for the AD9514. The PCB
attachment must provide a good thermal path to a larger heat
dissipation area, such as a ground plane on the PCB. This
requires a grid of vias from the top layer down to the ground
plane (see Figure 34). The AD9514 evaluation board
(AD9514/PCB) provides a good example of how the part
should be attached to the PCB.
Figure 34. PCB Land for Attaching Exposed Paddle
VIAS TO GND PLANE
Rev. 0 | Page 24 of 28
POWER MANAGEMENT
In some cases the AD9514 can be configured to use less power
by turning off functions that are not being used.
The power-saving options include the following:
•
•
•
Any divider is powered down when set to divide = 1
(bypassed).
Adjustable delay block on OUT2 is powered down when in
off mode (S0 = 0).
In some cases, an unneeded output can be powered down
(see Table 11). This also powers down the divider for that
output.