MT9M114 Aptina Imaging Corporation, MT9M114 Datasheet - Page 4

no-image

MT9M114

Manufacturer Part Number
MT9M114
Description
1/6-Inch 720P High-Definition (HD) System-On-A-Chip (SOC) Digital Image Sensor Die
Manufacturer
Aptina Imaging Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MT9M114EBLSTC
Manufacturer:
MICRON
Quantity:
1 000
Part Number:
MT9M114EBLSTCZ
Manufacturer:
ATI
Quantity:
60 000
Company:
Part Number:
MT9M114EBLSTCZ
Quantity:
50
Company:
Part Number:
MT9M114EBLSTCZ
Quantity:
50
Company:
Part Number:
MT9M114EBLSTCZ
Quantity:
698
Part Number:
MT9M114EBLSTCZ-CR
Manufacturer:
SEMIKRON
Quantity:
120
Company:
Part Number:
MT9M114EBLSTCZ-CR
Quantity:
5 000
Decoupling Capacitor Recommendations
PDF: 0834020843/Source:7792798679
MT9M114 DDS - Rev. A 9/09 EN
1. Mount 0.1µF and 1µF decoupling capacitors for each power supply as close as possi-
2. If module limitations allow for only six decoupling capacitors for a three-regulator
3. If module limitations allow for only three decoupling capacitors, use a 1µF capacitor
4. Give priority to the V
It is important to provide clean, well-regulated power to each power supply. The
customer is ultimately responsible for ensuring that clean power is provided for their
own designs because hardware design is influenced by many factors, such as layout,
operating conditions, and component selection.
The recommendations for capacitor placement and values listed below are based on our
internal demo camera design and verified in hardware.
In order of preference, Aptina recommends:
Inductive filtering components are not recommended.
Follow best practices when performing physical layout. Refer to technical note
TN-09-131.
4. Aptina recommends a 1.5kΩ resistor value for the two-wire serial interface R
5. All inputs must be configured with V
6. RESET_BAR has an internal pull-up resistor and can be left floating.
7. Aptina recommends that 0.1μF and 1μF decoupling capacitors for each power supply are mounted as
8. TRST_BAR connects to GND for normal operation.
ble to the pad and place a 10 µF capacitor nearby off-module.
design (V
lated supplies. Aptina also recommends placing a 10 µF capacitor for each supply off-
module, but close to each supply.
(preferred) or a 0.1 µF capacitor for each of the three regulated supplies. Aptina also
recommends placing a 10 µF capacitor for each supply off-module but close to each
supply.
values may be used for slower transmission speed.
close as possible to the pad. Actual values and numbers may vary depending on layout and design con-
siderations.
MT9M114 1/6-Inch 720P High-Definition (HD) System-On-A-Chip (SOC) Digital
DD
Aptina Confidential and Proprietary
_PLL tied to V
AA
supply for additional decoupling capacitors.
AA
4
), use a 0.1µF and 1µF capacitor for each of the three regu-
DD
_IO.
Aptina reserves the right to change products or specifications without notice.
©2009 Aptina Imaging Corporation. All rights reserved.
PULL
-
UP
Image Sensor Die
www.DataSheet4U.com
; however, greater
Advance

Related parts for MT9M114