isp1507a NXP Semiconductors, isp1507a Datasheet - Page 22

• Manufacturer Part Number: isp1507a
• Description: Lpi Hi-speed Universal Serial Bus On-the-go Transceive
• Manufacturer: NXP Semiconductors

NXP Semiconductors
ISP1507A_ISP1507B_1
Product data sheet
If a crystal is attached or a clock is driven into the XTAL1 pin, the ISP1507 will drive a
60 MHz clock out from the CLOCK pin when DIR deasserts. This is shown as CLOCK in
Figure
The recommended power-up sequence for the link is as follows:
The ULPI interface is ready for use.
1. The link waits for 1 ms, ignoring all the ULPI pin status.
2. The link may start to detect DIR status level. If DIR is detected as LOW for three clock
cycles, the link may send a RESET command.
6.
Rev. 01 — 19 May 2008
ISP1507A; ISP1507B
ULPI HS USB OTG transceiver
© NXP B.V. 2008. All rights reserved.
21 of 81