MC68HC908JK3EMP MOTOROLA [Motorola, Inc], MC68HC908JK3EMP Datasheet - Page 146

no-image

MC68HC908JK3EMP

Manufacturer Part Number
MC68HC908JK3EMP
Description
Microcontrollers
Manufacturer
MOTOROLA [Motorola, Inc]
Datasheet
Analog-to-Digital Converter (ADC)
11.4.2 Voltage Conversion
11.4.3 Conversion Time
11.4.4 Continuous Conversion
Technical Data
146
NOTE:
Writes to the port register or DDR will not have any affect on the port pin
that is selected by the ADC. Read of a port pin which is in use by the
ADC will return a logic 0 if the corresponding DDR bit is at logic 0. If the
DDR bit is at logic 1, the value in the port data latch is read.
When the input voltage to the ADC equals V
signal to $FF (full scale). If the input voltage equals V
converts it to $00. Input voltages between V
straight-line linear conversion. All other input voltages will result in $FF
if greater than V
Input voltage should not exceed the analog supply voltages.
Fourteen ADC internal clocks are required to perform one conversion.
The ADC starts a conversion on the first rising edge of the ADC internal
clock immediately following a write to the ADSCR. If the ADC internal
clock is selected to run at 1MHz, then one conversion will take 14µs to
complete. With a 1MHz ADC internal clock the maximum sample rate is
71.43kHz.
In the continuous conversion mode, the ADC continuously converts the
selected channel filling the ADC data register with new data after each
conversion. Data from the previous conversion will be overwritten
whether that data has been read or not. Conversions will continue until
the ADCO bit is cleared. The COCO bit (ADC status and control register,
$003C) is set after each conversion and can be cleared by writing the
ADC status and control register or reading of the ADC data register.
Number of Bus Cycles = Conversion Time × Bus Frequency
Analog-to-Digital Converter (ADC)
Conversion Time =
DD
and $00 if less than V
ADC Clock Frequency
14 ADC Clock Cycles
MC68H(R)C908JL3E/JK3E/JK1E
SS
.
DD
DD
, the ADC converts the
and V
SS
SS
, the ADC
are a
MOTOROLA
Rev. 2.0

Related parts for MC68HC908JK3EMP