AD9683-170EBZ Analog Devices, AD9683-170EBZ Datasheet - Page 31

• Manufacturer Part Number: AD9683-170EBZ
• Description: Data Conversion IC Development Tools
• Manufacturer: Analog Devices
• Type: ADCr
• Series: AD9683r

Specifications of AD9683-170EBZ

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: AD9683-170
• Interface Type: SPI
• Operating Supply Voltage: 1.8 V
• Description/function: Evaluation board with AD9683-170
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Current: 135 mA
• For Use With: AD9683-170

Data Sheet
DC CORRECTION (DCC)
Because the dc offset of the ADC may be significantly larger than
the signal being measured, a dc correction circuit is included to
null the dc offset before measuring the power. The dc correction
circuit can also be switched into the main signal path; however,
this may not be appropriate if the ADC is digitizing a time-varying
signal with significant dc content, such as GSM.
DC CORRECTION BANDWIDTH
The dc correction circuit is a high-pass filter with a programmable
bandwidth (ranging between 0.29 Hz and 2.387 kHz at
245.76 MSPS). The bandwidth is controlled by writing to
the four dc correction bandwidth select bits, located at
Address 0x40, Bits[5:2]. The following equation can be used
to compute the bandwidth value for the dc correction circuit:
where:
k is the 4-bit value programmed in Bits[5:2] of Address 0x40
(values between 0 and 13 are valid for k).
f
CLK
is the
DC_Corr_BW = 2
AD9683
ADC sample rate in hertz.
−k−14
× f
CLK
/(2 × π)
Rev. 0 | Page 31 of 44
DC CORRECTION READBACK
The current dc correction value can be read back in Address 0x41
and Address 0x42. The dc correction value is a 16-bit value that
can span the entire input range of the ADC.
DC CORRECTION FREEZE
Setting Bit 6 of Address 0x40 freezes the dc correction at its
current state and continues to use the last updated value as the
dc correction value. Clearing this bit restarts dc correction and
adds the currently calculated value to the data.
DC CORRECTION ENABLE BITS
Setting Bit 1 of Address 0x40 enables dc correction for use in
the output data signal path.
AD9683