MD2534-D2G-X-P SanDisk, MD2534-D2G-X-P Datasheet - Page 50

• Manufacturer Part Number: MD2534-D2G-X-P
• Description: IC MDOC H3 2GB FBGA
• Manufacturer: SanDisk

Specifications of MD2534-D2G-X-P

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 2G (256M x 8)
• Interface: Parallel
• Voltage - Supply: 1.65 V ~ 1.95 V, 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 115-TFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

Note: This register cannot be accessed when the A0 signal is pulled high. Therefore it is
7.3.17 Software Lock Register
Description:
Address (hex): 9410 (128KB window) / 1410 (8KB window)
Type:
Note: This register cannot be accessed when the A0 signal is pulled high. Therefore it is
50
Bit number
Read/Write R
Bit name
Reset value
DMA_PROG_NEG
Bit number
Read/Write
Bit name
Reset value
SLOCK
recommended that A0 will be connected to Host CPU A0, or to VSS.
recommended that A0 will be connected to Host CPU A0, or to VSS.
D15-D10
RFU
0
D15-D1
R
RFU
0
This 16-bit register implements the Sticky Lock functionality. After setting it,
protected-partitions can no longer be accessed, until the device is reset.
Read / Write
Sticky Lock bit.
0: Sticky Lock is not active
1: Sticky Lock is activated
This bit can only be set once by the host until device is reset.
DMA programmable negation:
0-1023: Number of clocks before end of data transfer that DMARQ#
signal will be negated.
Note: DMA negation must be smaller than transfer size in words
(16bit).
D9-D0
R/W
DMA_PROG_NEG
4
Data Sheet (Preliminary) Rev. 0.2
D0
R/W
SLOCK
0
mDOC H3 Embedded Flash Drive
92-DS-1205-10