MAX1402EVKIT Maxim Integrated Products, MAX1402EVKIT Datasheet - Page 13

• Manufacturer Part Number: MAX1402EVKIT
• Description: EVAL KIT FOR MAX1402
• Manufacturer: Maxim Integrated Products

Specifications of MAX1402EVKIT

• Number Of Adc's: 1
• Number Of Bits: 18
• Sampling Rate (per Second): 480
• Data Interface: Serial
• Inputs Per Adc: 6 Single Ended
• Input Range: ±VREF/2
• Power (typ) @ Conditions: 26.7mW @ 480SPS
• Voltage Supply Source: Analog and Digital
• Operating Temperature: 0°C ~ 70°C
• Utilized Ic / Part: MAX1402
• Interface Type: SMA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: MAX1402

The MAX1402 is a low-power, multichannel, serial-output,
sigma-delta ADC designed for applications with a wide
dynamic range, such as weigh scales and pressure
transducers. The functional block diagram in Figure 2
contains a switching network, a modulator, a PGA, two
buffers, an oscillator, an on-chip digital filter, and a
bidirectional serial communications port.
Three fully-differential input channels feed into the
switching network. Each channel may be independent-
ly programmed with a gain between +1V/V and
+128V/V. These three differential channels may also be
configured to operate as five pseudo-differential input
channels. Two additional, fully differential system-cali-
bration channels allow system gain and offset error to
be measured. These system-calibration channels can
be used as additional differential signal channels when
dedicated gain and offset error correction channels are
not required.
Figure 2. Functional Diagram
_______________Detailed Description
CALGAIN+
CALGAIN-
CALOFF+
CALOFF-
REFIN+
REFIN-
OUT1
OUT2
AIN5
AIN1
AIN6
AIN2
AIN3
AIN4
SWITCHING
______________________________________________________________________________________
NETWORK
V+
+5V, 18-Bit, Low-Power, Multichannel,
AGND
V+
Circuit Description
Oversampling (Sigma-Delta) ADC
BUFFER
BUFFER
MAX1402
PGA
Two chopper-stabilized buffers are available to isolate
the selected inputs from the capacitive loading of the
PGA and modulator. Three independent DACs provide
compensation for the DC component of the input signal
on each of the differential input channels.
The sigma-delta modulator converts the input signal into
a digital pulse train whose average duty cycle represents
the digitized signal information. The pulse train is then
processed by a digital decimation filter, resulting in a
conversion accuracy exceeding 16 bits. The digital filter’s
decimation factor is user-selectable, which allows the
conversion result’s resolution to be reduced to achieve a
higher output data rate. When used with 2.4576MHz or
1.024MHz master clocks, the decimation filter can be
programmed to produce zeros in its frequency response
at the line frequency and associated harmonics. This
ensures excellent line rejection without the need for fur-
ther post-filtering. In addition, the modulator sampling
frequency can be optimized for either lowest power dis-
sipation or highest output data rate.
DAC
MODULATOR
DIVIDER
AND CONTROL
INTERFACE
DIGITAL
FILTER
CLOCK
GEN
V
DGND
V+
AGND
SCLK
DIN
DOUT
INT
CS
RESET
DS1
DS0
CLKIN
CLKOUT
DD
13