M68ICS05KJ Freescale Semiconductor, M68ICS05KJ Datasheet - Page 16

• Manufacturer Part Number: M68ICS05KJ
• Description: SIM PROGRAM FOR 68HC705KJ/J1A
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS05KJ

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC705KJ/JIA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

INTRODUCTION
1.7 QUICK START INSTRUCTIONS
The following instructions summarize the hardware and software installation instructions of
Chapters 2 and 3.
If you are experienced in installing Motorola or other development tools, follow these steps.
1-4
Install the ICS05KJW software: follow the instructions on the diskette label to run
the ICS05KJW Setup program. During installation, follow the instructions in the
installation wizard: choose the Typical Install option to install the files to your hard
disk, or choose the Compact Install option to copy the files onto another diskette.
Connect the M68ICS05KJ pod: connect the M68ICS05KJ pod to the host PC’s
serial port using the included cable. Plug the cable into the pod connector P2.
Supply power to the M68ICS05KJ pod: connect the wall-mounted transformer’s
circular connector to the connector on the left side of the pod, next to the serial
connector.
Start the WinIDE editor and open the project files: Double click the WinIDE icon.
From the WinIDE Environment menu, choose the Open Project option, and choose a
project file from the Specify project file to open dialog. If no project file exists,
choose the New option from the File menu to create a new project file. Paragraph 8.3
gives additional information about setting up a sample project.
Configure the environment for the ICS05KJW software components: from the
WinIDE Environment menu, select the Setup Environment option to open the
Environment Settings dialog and make the following changes:
See the Electrostatic Discharge Precaution in section 3.1
Click on the EXE1 Debugger tab to bring the tab (Figure 1-1) to the front. Set
the executable type, path and filename, command line options (including
optional switches, filenames, or port settings), and other options for the
ICS05KJW debugger application.
CAUTION
M68ICS05KJOM/D