M68ICS05KJ Freescale Semiconductor, M68ICS05KJ Datasheet - Page 227

• Manufacturer Part Number: M68ICS05KJ
• Description: SIM PROGRAM FOR 68HC705KJ/J1A
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS05KJ

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC705KJ/JIA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

B.5
Figures B-1 through B-3 show the M68ICS05KJ diagram.
Table B-1 itemizes and describes the M68ICS05KJ parts list.
Figure B-4 shows the M68ICS05KJ board layout and component locations.
M68ICS05KJOM/D
3. On the host computer, with the ICS05KJW software running, enter the
4. Choose the
5. If there is activity on pin 1 of socket XU9, choose the
SCHEMATIC DIAGRAM, PARTS LIST, AND BOARD LAYOUT
command and follow the programming instructions that appear on the screen.
Before reinserting the 705KJ/J1A device, make sure that its erase window is covered.
oscilloscope on pin 1 of socket XU9.
If there is no activity, there is a problem with the circuit board or with the C8A MCU
(U4). Call Motorola for replacement parts.
If the result of the
erase or replace the 705KJ/J1A MCU.
oscilloscope to measure V
should not drop below 16 Vdc. If V
or the MC34063 MCU is defective. Call Motorola for replacement parts.
a. Turn switches S1 and S2 on.
b. Adjust potentiometer VR1 until the voltage is 16.5 ± 0.5 Vdc.
c. Turn switches S1 and S2 off.
BLANK CHECK
BLANK CHECK
PP
programming option. Activity should be visible with an
as the 705KJ/J1A MCU is being programmed. V
TECHNICAL REFERENCE AND TROUBLESHOOTING
PP
programming operation is
does drop below 16 Vdc, either the 705KJ/J1A
PROGRAM
PART NOT BLANK
option. Use the
PROGRAM
B-5
PP
,