MC56F8346VFVER2 Freescale Semiconductor, MC56F8346VFVER2 Datasheet - Page 20

• Manufacturer Part Number: MC56F8346VFVER2
• Description: IC HYBRID CTRLR 16BIT 144-LQFP
• Manufacturer: Freescale Semiconductor
• Series: 56F8xxxr

Specifications of MC56F8346VFVER2

• Core Processor: 56800
• Core Size: 16-Bit
• Speed: 60MHz
• Connectivity: CAN, EBI/EMI, SCI, SPI
• Peripherals: POR, PWM, Temp Sensor, WDT
• Number Of I /o: 62
• Program Memory Size: 136KB (68K x 16)
• Program Memory Type: FLASH
• Ram Size: 6K x 16
• Voltage - Supply (vcc/vdd): 2.25 V ~ 3.6 V
• Data Converters: A/D 16x12b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 144-LQFP
• For Use With: MC56F8367EVME - EVAL BOARD FOR MC56F83X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

2.2 Signal Pins
After reset, each pin is configured for its primary function (listed first). Any alternate functionality must
be programmed.
Note: Signals in italics are NOT available in the 56F8146 device.
If the “State During Reset” lists more than one state for a pin, the first state is the actual reset state. Other
states show the reset condition of the alternate function, which you get if the alternate pin function is
selected without changing the configuration of the alternate peripheral. For example, the A8/GPIOA0 pin
shows that it is tri-stated during reset. If the GPIOA_PER is changed to select the GPIO function of the
pin, it will become an input if no other registers are changed.
20
V
Signal Name
DDA_OSC_PLL
V
V
DDA_ADC
SSA_ADC
V
V
V
V
V
V
V
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
V
V
V
V
V
SS
SS
SS
SS
SS
Table 2-2 Signal and Package Information for the 144 Pin LQFP
Pin No.
119
102
144
103
16
31
38
66
84
80
27
37
63
69
1
Supply
Supply
Supply
Supply
Supply
Type
During
56F8346 Technical Data, Rev. 15
Reset
State
I/O Power — This pin supplies 3.3V power to the chip I/O interface
and also the Processor core throught the on-chip voltage regulator,
if it is enabled.
ADC Power — This pin supplies 3.3V power to the ADC modules.
It must be connected to a clean analog power supply.
Oscillator and PLL Power — This pin supplies 3.3V power to the
OSC and to the internal regulator that in turn supplies the Phase
Locked Loop. It must be connected to a clean analog power
supply.
V
ADC Analog Ground — This pin supplies an analog ground to the
ADC modules.
SS
— These pins provide ground for chip logic and I/O drivers.
Signal Description
Freescale Semiconductor
Preliminary