R4F24268NVRFQV Renesas Electronics America, R4F24268NVRFQV Datasheet - Page 503

• Manufacturer Part Number: R4F24268NVRFQV
• Description: MCU 256KB FLASH 48K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24268NVRFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 48K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

H8S/2426, H8S/2426R, H8S/2424 Group
(4)
At the start of activation source acceptance, low level sensing is used for both falling edge sensing
and low level sensing on the EDREQ pin. Therefore, a request is accepted in the case of a low
level at the EDREQ pin that occurs before execution of the EDMDR write for setting the transfer-
enabled state.
When the EXDMAC is activated, make sure, if necessary, that a low level does not remain at the
EDREQ pin from the previous end of transfer, etc.
(5)
When transfer is started while the IRF bit is set to 1 in EDMDR, if the EDIE bit is set to 1 in
EDMDR together with the EDA bit in EDMDR, enabling interrupt requests, an interrupt will be
requested since EDIE = 1 and IRF = 1. To prevent the occurrence of an erroneous interrupt request
when transfer starts, ensure that the IRF bit is cleared to 0 before the EDIE bit is set to 1.
(6)
If the last EXDMAC transfer cycle and a CBR refresh cycle* occur simultaneously, note that
although the CBR refresh* and the last transfer cycle may be executed consecutively, ETEND
may also go low in this case for the refresh cycle*.
Note: * Not supported in the 5-V version.
REJ09B0466-0350 Rev. 3.50
Jul 09, 2010
Activation Source Acceptance
Enabling Interrupt Requests when IRF = 1 in EDMDR
ETEND Pin and CBR Refresh Cycle*
Section 8 EXDMA Controller (EXDMAC)
Page 473 of 1372