ATA5773-PXQW Atmel, ATA5773-PXQW Datasheet - Page 12

• Manufacturer Part Number: ATA5773-PXQW
• Description: XMITTR UHF ASK/FSK 310MHZ 24VQFN
• Manufacturer: Atmel

Specifications of ATA5773-PXQW

• Frequency: 310MHz ~ 350MHz
• Modulation Or Protocol: UHF
• Power - Output: 8dBm
• Voltage - Supply: 2 V ~ 4 V
• Current - Transmitting: 9.8mA
• Data Interface: PCB, Surface Mount
• Memory Size: 4kB Flash, 256B EEPROM, 256B SRAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 24-VQFN Exposed Pad, 24-HVQFN, 24-SQFN, 24-DHVQFN
• Processor Series: ATA5x
• Core: AVR8
• Data Bus Width: 8 bit
• Program Memory Type: Flash
• Program Memory Size: 4 KB
• Data Ram Size: 256 B
• Interface Type: SPI, USI
• Maximum Clock Frequency: 4 MHz
• Number Of Programmable I/os: 12
• Number Of Timers: 2
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 12 Channel
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Sensitivity: -
• Data Rate - Maximum: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Details

®
The Atmel AVR
core combines a rich instruction set with 32 general purpose working regis-
ters. All the 32 registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two
independent registers to be accessed in one single instruction executed in one clock cycle.
The resulting architecture is more code efficient while achieving throughputs up to ten times
faster than conventional CISC microcontrollers.
The Atmel ATtiny44V provides the following features: 4K byte of In-System Programmable
Flash, 256 bytes EEPROM, 256 bytes SRAM, 12 general purpose I/O lines, 32 general pur-
pose working registers, a 8-bit Timer/Counter with two PWM channels, a 16-bit timer/counter
with two PWM channels, Internal and External Interrupts, a 8-channel 10-bit ADC, program-
mable gain stage (1x, 20x) for 12 differential ADC channel pairs, a programmable Watchdog
Timer with internal Oscillator, internal calibrated oscillator, and three software selectable
power saving modes. The Idle mode stops the CPU while allowing the SRAM, Timer/Counter,
ADC, Analog Comparator, and Interrupt system to continue functioning. The Power-down
mode saves the register contents, disabling all chip functions until the next Interrupt or Hard-
ware Reset. The ADC Noise Reduction mode stops the CPU and all I/O modules except ADC,
to minimize switching noise during ADC conversions. In Standby mode, the crystal/resonator
Oscillator is running while the rest of the device is sleeping. This allows very fast start-up com-
bined with low power consumption.
The device is manufactured using the Atmel high density non-volatile memory technology. The
On-chip ISP Flash allows the Program memory to be re-programmed In-System through an
SPI serial interface, by a conventional non-volatile memory programmer or by an On-chip boot
code running on the AVR core.
The ATtiny44V AVR is supported with a full suite of program and system development tools
including: C Compilers, Macro Assemblers, Program Debugger/Simulators, In-Circuit Emula-
tors, and Evaluation kits.
4.3
Automotive Quality Grade
The ATtiny44V have been developed and manufactured according to the most stringent
requirements of the international standard ISO-TS-16949 grade 1. This data sheet contains
limit values extracted from the results of extensive characterization (Temperature and Volt-
age). The quality and reliability of the ATtiny44V have been verified during regular product
qualification as per AEC-Q100.
As indicated in the ordering information paragraph, the product is available in only one temper-
ature grade.
Table 4-1.
Temperature Grade Identification for Automotive Products
Temperature
Temperature
Comments
Identifier
-40 ; +125
Z
Full Automotive Temperature Range
Atmel ATA5771/73/74
12
9137E–RKE–12/10