CV500ETN01 Omron, CV500ETN01 Datasheet - Page 36

• Manufacturer Part Number: CV500ETN01
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500ETN01

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1-3
1-3-1
1-3-2
Recommended Hubs
1-3-3
Making Settings in the
CPU Bus Unit System
Setup Area (with the CX-
Programmer)
System Configuration
System Configuration
System Configuration
Devices Required for Constructing a Network
Setup Area and Related Peripheral Devices
CX-Programmer
CX-Integrator
FinsGateway
The basic configuration for a 100Base-TX Ethernet System consists of one
hub to which nodes are attached in star form using twisted-pair cable.
The devices shown in the following table are required to configure a network
with 100Base-TX-type CS1W-ETN21 and CJ1W-ETN21 Ethernet Units, so
prepare them in advance.
For details on recommended devices for constructing a network, refer to 2-4
Network Installation.
For the Ethernet Unit to function as a node on an Ethernet network, make the
settings, as required, in the CPU Bus Unit System Setup Area allocated in
non-volatile memory in the CPU Unit.
Use the CX-Programmer to make the settings (by connecting online from the
I/O Table Window, selecting the Ethernet Unit, and then selecting Unit Setup).
Each time the Ethernet Unit is turned ON or restarted, it reads and uses the
contents of the CPU Bus Unit System Setup Area as the settings for the com-
munications services.
(3) Hub
(1) CS-series Ethernet
(2) Twisted-pair cable
(3) Hub
100 m
max.
Units (CS1W-ETN21)
or CJ-series Ethernet
Units (CJ1W-ETN21)
Network device
(1) CS1W-ETN21
Ethernet Unit
(100Base-TX)
(2) Twisted-pair cable
CS-series
PLC
These Ethernet Units are Communications Units that
connect a CS-series or CJ-series PLC to 100Base-TX
Ethernet networks. (They can also be used as 10Base-T.)
This is twisted-pair cable for connecting 100Base-TX-type
Ethernet Units to the hub, with an RJ45 Modular Connec-
tor at each end.
Use a category 3, 4, 5, or 5e UTP (unshielded twisted-
pair) or STP (shielded twisted-pair) cable.
This is a relay device for connecting multiple nodes in a
star LAN.
Contents
(1) CJ1W-ETN21
Ethernet Unit
(100Base-TX)
CJ-series
PLC
Section 1-3
11