CV500-ZS3AT1-EV2 Omron, CV500-ZS3AT1-EV2 Datasheet - Page 69

• Manufacturer Part Number: CV500-ZS3AT1-EV2
• Description: C.V SOFTWARE 3.5in DISK
• Manufacturer: Omron

Specifications of CV500-ZS3AT1-EV2

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Power Supply Units
56
!
!
WARNING
!
Caution
Caution
Note The RUN output on Slave Racks will go OFF when a remote I/O error occurs.
Use round crimp terminals for wiring. Do not connect bare stranded wires direct-
ly to terminal blocks. Use M3.5 screws for tightening crimp terminals.
Tighten the screws on the terminal block of the AC Power Supply Unit to a torque
of 0.8 N m. The loose screws may result in short-circuit, burning, or malfunc-
tion.
Always attach crimp terminals to the wires to ensure proper connection.
Connecting loose wires can cause fires.
Abide by the following precautions when wiring the Power Supply Units. Failure
to abide by these precautions my cause faulty operation or damage to the Unit.
7 mm max.
20 mm max.
Be sure that no wire clippings or other foreign materials enter the Units when
wiring.
Check and recheck all wiring before supplying power to the system.
Tightening torque: 0.8 N m
M3.5 screw
Section 3-4