CS1D-BC042D Omron, CS1D-BC042D Datasheet - Page 481

• Manufacturer Part Number: CS1D-BC042D
• Description: CS1D Dual CPU Exp
• Manufacturer: Omron

Specifications of CS1D-BC042D

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Online Replacement of I/O Units, Special I/O Units, and CPU Bus Units
446
Ethernet Units
Ethernet units
Serial Communica-
tions Unit
CS1W-ETN01
CS1W-ETN11
CS1W-ETN21
CS1D-ETN21D
CS1W-SCU21-V1
CS1W-SCU31-V1
Name and model
number
CPU Bus Unit
Unit number
(rotary switch)
Node address
(rotary switch)
IP address
(rotary switch)
Unit number
(rotary switch)
Node address
(rotary switch)
Unit number
(rotary switch)
settings on
Hardware
In CPU Bus
Setup Area:
Network settings
• Routing tables
In allocated DM
Area words:
• Various set-
tings
In CPU Bus
Setup Area:
• Network set-
tings
(e.g., IP
address)
• Routing tables
In allocated DM
Area words:
• Various set-
tings
In allocated DM
Area words:
• Baud rate, oth-
ers
Settings stored
in CPU Unit
Settings
None
None
In flash memory:
• Protocol macro
data
Settings stored
in CPU Bus
Unit
Refer to the Ethernet Unit operation manual for replacement
procedures and observe the following precautions.
1) Turn OFF the power supply connected to the Unit before
2) Set the same unit number, node address, and I/P
3) When the new Unit has been mounted and the online
Refer to the Ethernet Unit operation manual for replacement
procedures and observe the following precautions.
1) Set the same unit number and node address, on the new
2) When the new Unit has been mounted and the online
Refer to the Serial Communications Unit operation manual
for replacement procedures, and observe the following pre-
cautions.
1) Turn OFF the power supply to all external devices con-
2) Set the same unit number on the new Unit as was set on
3) When the new Unit has been mounted and the online
4) If protocol macros are being used, use one of the follow-
Note The version 1 (-V1) Serial Communications Units sup-
starting the replacement procedure.
address on the new Unit as were set on the Unit being
replaced.
replacement operation has been completed for it, the set-
tings stored in the CPU Unit will be automatically trans-
ferred to the new Unit.
Unit as were set on the Unit being replaced.
replacement operation has been completed for it, the set-
tings stored in the CPU Unit will be automatically trans-
ferred to the new Unit.
nected to the Unit before starting the replacement proce-
dure.
the Unit being replaced.
replacement operation has been completed for it, the set-
tings stored in the CPU Unit will be automatically trans-
ferred to the new Unit.
ing methods to transfer the same data to the flash mem-
ory in the Special I/O Unit as was in the Unit that was
replaced: a) Use the simple backup function or b) Trans-
fer the required data from the CX-Protocol.
port a simple backup function. If the data stored in the
flash memory in the Unit is saved to a Memory Card in
advance and the Memory Card is inserted into the
CPU Unit, the Memory Card can be used after online
replacement to automatically transfer the required
data to the new Unit. (See note 1.)
Pre-V1 versions of the Units do not support the simple
backup operation. Use the CX-Protocol to either
transfer the required data or set it again to the same
settings as the Unit being replaced. (See note 2.)
Precautions
Section 11-4