82V2082PF IDT, Integrated Device Technology Inc, 82V2082PF Datasheet - Page 14

• Manufacturer Part Number: 82V2082PF
• Manufacturer: IDT, Integrated Device Technology Inc

Specifications of 82V2082PF

• Number Of Transceivers: 1
• Screening Level: Industrial
• Mounting: Surface Mount
• Package Type: TQFP
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Lead Free Status / RoHS Status: Not Compliant

Table-1 Pin Description (Continued)
PIN DESCRIPTION
IDT82V2082
PATT11
PATT10
SCLKE
Name
SCLK
LP21
R/W
SDI
WR
RD
DS
Type
I
I
I
TQFP80
Pin No.
46
45
44
FPBGA81
Pin No.
G7
H8
F8
SCLK: Shift Clock
In serial microcontroller interface mode, this signal is the shift clock for the serial interface. Configuration data on SDI pin
is sampled on the rising edge of SCLK. Configuration and status data on SDO pin is clocked out of the device on the rising
edge of SCLK if SCLKE pin is low, or on the falling edge of SCLK if SCLKE pin is high.
In parallel non-multiplexed interface mode, this pin should be connected to ground.
PATT11/PATT10: Transmit pattern select for channel 1
In hardware control mode, this pin selects the transmit pattern
•
•
•
•
SCLKE: Serial Clock Edge Select
In serial microcontroller interface mode, this signal selects the active edge of SCLK for outputting SDO. The output data
is valid after some delay from the active clock edge. It can be sampled on the opposite edge of the clock. The active clock
edge which clocks the data out of the device is selected as shown below:
DS: Data Strobe
In Motorola parallel non-multiplexed interface mode, this signal is the data strobe of the parallel interface. In a write oper-
ation (R/W = 0), the data on D[7:0] is sampled into the device. In a read operation (R/W = 1), the data is driven to D[7:0]
by the device.
RD: Read Strobe
In Intel parallel non-Multiplexed interface mode, the data is driven to D[7:0] by the device during low level of RD in a read
operation.
PATT11/PATT10: Transmit pattern select for channel 1
See above PATT11.
SDI: Serial Data Input
In serial microcontroller interface mode, this signal is the input data to the serial interface. Configuration data at SDI pin
is sampled by the device on the rising edge of SCLK.
R/W: Read/Write Select
In Motorola parallel non-multiplexed interface mode, this pin is low for write operation and high for read operation.
WR: Write Strobe
In Intel parallel non-multiplexed interface mode, this pin is asserted low by the microcontroller to initiate a write cycle. The
data on D[7:0] is sampled into the device in a write operation.
LP21/LP20: loopback mode select for channel 2
When the chip is configured by hardware, this pin is used to select loopback operation modes for channel 2 (Inband Loop-
back is not provided in hardware control mode).
•
•
•
•
00 = normal
01= All Ones
10= PRBS
11= transmitter power down
00 = no loopback
01 = analog loopback
10 = digital loopback
11 = remote loopback
DUAL CHANNEL T1/E1/J1 LONG HAUL/SHORT HAUL LINE INTERFACE UNIT
SCLKE
High
Low
14
Rising edge is the active edge.
Falling edge is the active edge.
Description
SCLK
May 4, 2009