TMC22053KHC Fairchild Semiconductor, TMC22053KHC Datasheet - Page 45

• Manufacturer Part Number: TMC22053KHC
• Manufacturer: Fairchild Semiconductor

Specifications of TMC22053KHC

• Screening Level: Commercial
• Package Type: MQFP
• Pin Count: 100
• Lead Free Status / RoHS Status: Compliant

PRODUCT SPECIFICATION
The primary and secondary inputs are selected within the
input processor. The primary input is normally the undelayed
composite video signal in line, field, and frame based comb
filters or either the luma or chroma channel when processing
YC or D1 signals. The secondary provides the field or frame
delayed composite input for field and frame based comb
filters and the chroma or luma channel when processing YC
or D1 signals.
When implementing a line based comb filter the outputs of
1H bandsplit filter, ie 1HH, 1HL, are delayed through the
second line store, LSTORE2. The number of bits delayed is
dependent upon the type of comb filter being implemented.
For chroma comb filters all the bits of the 1HH signal are
delayed, as this information supplies the outer tap of the
chroma comb filter, while only the upper bits of 1HL are
delayed as this data is used only in the generation of the
Secondary
Input
Primary
Input
LS1IN
MUX
2:1
BSFSEL
LPF
Figure 15. Block Diagram of Comb Filter Input
1HH
1HL
LSTORE1
1HH (lsbs)
1HL (lsbs)
[9:0]
Split
–
MUX
2:1
LS1BY
MUX
2:1
LSTORE2
LSTORE2
LSTORE2
luma error signals. In the case of luma combs an equal
number of bits of the 1HH and 1HL signals are delayed and
summed together to produce the 2HF signal for the outer tap
of the luma comb filter. The configuration of LSTORE2 is
determined by the SPLIT register bit.
It is important to note that when implementing a field or
frame based comb filter the secondary input must be selected
by setting the LSIN register bit HIGH, and the first line store,
LSTORE1, must be bypassed by setting the LS1BY register
bit HIGH.
For YC and D1 processing the secondary input bypasses the
comb filter completely and provides the VIDEOB signal
input the 3:1 multiplexer used to select the FLAT signal,
see Figure 16.
2HH
2HX
2HL
BSFSEL
LPF
+
DELAY
–
MUX
2:1
65-22x5y-56
0HF
0HL
1HH
1HF
1HL
1HH
2HH
2HF
2HL
VIDEOB
TMC22x5y
45