ISP1362BDFA STEricsson, ISP1362BDFA Datasheet - Page 2

• Manufacturer Part Number: ISP1362BDFA
• Manufacturer: STEricsson

Specifications of ISP1362BDFA

• Lead Free Status / RoHS Status: Compliant

1.
2.
ISP1362_7
Product data sheet
SoftConnect is a trademark of ST-Ericsson.
GoodLink is a trademark of ST-Ericsson.
USB device:
Supports two USB ports: port 1 and port 2
Supports software-controlled connection to the USB bus (SoftConnect
Supports good USB connection indicator that blinks with traffic (GoodLink
Complies with USB power management requirements
Supports internal power-on and low-voltage reset circuit, with possibility of a software
reset
High-speed parallel interface to most CPUs available in the market, such as Hitachi
SH-3, Intel StrongARM, NXP XA, Fujitsu SPARClite, NEC and Toshiba MIPS, ARM7/9,
Freescale DragonBall and PowerPC Reduced Instruction Set Computer (RISC):
Supports Programmed I/O (PIO) or DMA
Supports suspend and remote wake-up
Uses 12 MHz crystal or direct clock source with on-chip Phase-Locked Loop (PLL) for
low ElectroMagnetic Interference (EMI)
Operates at 3.3 V power supply
Operating temperature range from −40 °C to +85 °C
Available in 64-pin LQFP and TFBGA packages
USB host:
Supports integrated physical 4096 bytes of multiconfiguration memory
Supports all four types of USB transfers: control, bulk, interrupt and isochronous
Supports multiframe buffering for isochronous transfer
Supports automatic interrupt polling rate mechanism
Supports paired buffering for bulk transfer
Directly addressable memory architecture; memory can be updated on-the-fly
Supports high performance USB interface device with integrated Serial Interface
Engine (SIE), buffer memory and transceiver
Supports fully autonomous and multiconfiguration Direct Memory Access (DMA)
operation
Supports up to 14 programmable USB endpoints with two fixed control IN/OUT
endpoints
Supports integrated physical 2462 bytes of multiconfiguration memory
Supports endpoints with double buffering to increase throughput and ease
real-time data transfer
Supports controllable LazyClock (110 kHz ± 50 %) output during ‘suspend’
Port 1 can be configured to function as a downstream port, an upstream port or an
OTG port
Port 2 can be used only as a downstream port
16-bit data bus
10 MB/s data transfer rate between the microprocessor and the ISP1362
Rev. 07 — 29 September 2009
Single-chip USB OTG controller
© ST-ERICSSON 2009. All rights reserved.
ISP1362
1
)
2
)
2 of 147