TE28F800C3TA110 Micron Technology Inc, TE28F800C3TA110 Datasheet - Page 41
![no-image](/images/manufacturer_photos/0/4/441/micron_technology_inc_sml.jpg)
TE28F800C3TA110
Manufacturer Part Number
TE28F800C3TA110
Description
Manufacturer
Micron Technology Inc
Datasheet
1.TE28F800C3TA110.pdf
(70 pages)
Specifications of TE28F800C3TA110
Density
8Mb
Access Time (max)
110ns
Interface Type
Parallel
Boot Type
Top
Address Bus
19b
Operating Supply Voltage (typ)
3/3.3V
Operating Temp Range
-40C to 85C
Package Type
TSOP
Sync/async
Asynchronous
Operating Temperature Classification
Industrial
Operating Supply Voltage (min)
2.7V
Operating Supply Voltage (max)
3.6V
Word Size
16b
Number Of Words
512K
Supply Current
18mA
Mounting
Surface Mount
Pin Count
48
Lead Free Status / Rohs Status
Not Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
TE28F800C3TA110
Manufacturer:
TI
Quantity:
201
C3 Discrete
10.0
10.1
10.1.1
10.1.2
March 2008
290645-24
Modes of Operation
Read Mode
The flash memory has four read modes (read array, read identifier, read status, and CFI
query) and two write modes (program and erase). Three additional modes (erase
suspend to program, erase suspend to read, and program suspend to read) are
available only during suspended operations.
page 45
commands used for these modes.
Appendix A, “Write State Machine States” on page 53
showing the state transitions.
Read Array
When RP# transitions from V
and will respond to the read-control inputs (CE#, address inputs, and OE#) without any
additional CUI commands.
When the device is in read array mode, four control signals control data output.
In addition, the address of the desired location must be applied to the address pins. If
the device is not in read-array mode, as would be the case after a Program or Erase
operation, the Read Array command (0xFF) must be issued to the CUI before array
reads can occur.
Read Identifier
The read-identifier mode outputs three types of information: the manufacturer/device
identifier, the block locking status, and the protection register. The device is switched to
this mode by issuing the Read Identifier command (0x90). Once in this mode, read
cycles from addresses shown in
read-array mode, issue the Read Array command (0xFF).
• WE# must be logic high (V
• CE# must be logic low (V
• OE# must be logic low (V
• RP# must be logic high (V
and
Table 24, “Command Codes and Descriptions” on page 46
IL
IL
IL
IH
IH
)
)
(reset) to V
Table 22
)
)
retrieve the specified information. To return to
IH
Table 23, “Command Bus Operations” on
, the device defaults to read-array mode
is a comprehensive chart
summarize the
Datasheet
41