ATmega1284RZAP Atmel Corporation, ATmega1284RZAP Datasheet - Page 292

• Manufacturer Part Number: ATmega1284RZAP
• Manufacturer: Atmel Corporation

Specifications of ATmega1284RZAP

• Flash (kbytes): 128 Kbytes
• Max. Operating Frequency: 20 MHz
• Max I/o Pins: 32
• Spi: 3
• Twi (i2c): 1
• Uart: 2
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Crypto Engine: No
• Sram (kbytes): 16
• Eeprom (bytes): 4096
• Operating Voltage (vcc): 1.8 to 3.6
• Timers: 3
• Frequency Band: 2.4 GHz
• Max Data Rate (mb/s): 0.25
• Antenna Diversity: No
• External Pa Control: No
• Power Output (dbm): 3
• Receiver Sensitivity (dbm): -101
• Receive Current Consumption (ma): 16.0
• Transmit Current Consumption (ma): 17.0
• Link Budget (dbm): 104

25.2
8059D–AVR–11/09
Fuse Bits
Table 25-2.
Notes:
The ATmega1284P has four Fuse bytes.
ity of all the fuses and how they are mapped into the Fuse bytes. Note that the fuses are read as
logical zero, “0”, if they are programmed.
Table 25-3.
Note:
–
–
–
–
–
BODLEVEL2
BODLEVEL1
BODLEVEL0
BLB1 Mode
Fuse Low Byte
1
2
3
4
1. Program the Fuse bits and Boot Lock bits before programming the LB1 and LB2.
2. “1” means unprogrammed, “0” means programmed
1. See
Memory Lock Bits
(1)
(1)
(1)
Lock Bit Protection Modes
Extended Fuse Byte
”System and Reset Characteristics” on page 327
BLB12
1
1
0
0
7
6
5
4
3
2
1
0
Bit No
BLB11
1
0
0
1
Description
–
–
–
–
–
Brown-out Detector trigger level
Brown-out Detector trigger level
Brown-out Detector trigger level
Protection Type
No restrictions for SPM or (E)LPM accessing the Boot Loader
section.
SPM is not allowed to write to the Boot Loader section.
SPM is not allowed to write to the Boot Loader section, and
(E)LPM executing from the Application section is not allowed to
read from the Boot Loader section. If Interrupt Vectors are
placed in the Application section, interrupts are disabled while
executing from the Boot Loader section.
(E)LPM executing from the Application section is not allowed to
read from the Boot Loader section. If Interrupt Vectors are
placed in the Application section, interrupts are disabled while
executing from the Boot Loader section.
(1)(2)
Table 25-3
(Continued)
-
Table 25-5
for BODLEVEL Fuse decoding.
describe briefly the functional-
ATmega1284P
Default Value
1
1
1
1
1
1 (unprogrammed)
1 (unprogrammed)
1 (unprogrammed)
292