M55800A Atmel Corporation, M55800A Datasheet - Page 167

• Manufacturer Part Number: M55800A
• Manufacturer: Atmel Corporation

Specifications of M55800A

• Flash (kbytes): 0 Kbytes
• Pin Count: 176
• Max. Operating Frequency: 33 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 58
• Ext Interrupts: 58
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Uart: 3
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 72
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.3/5.0
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

1745F–ATARM–06-Sep-07
The Timer Counter channel can also be configured to have an external trigger. In Capture Mode,
the external trigger signal can be selected between TIOA and TIOB. In Waveform Mode, an
external event can be programmed on one of the following signals: TIOB, XC0, XC1 or XC2.
This external event can then be programmed to perform a trigger by setting ENETRG in
TC_CMR.
If an external trigger is used, the duration of the pulses must be longer than the system clock
(MCK) period in order to be detected.
• Software Trigger: Each channel has a software trigger, available by setting SWTRG in
• SYNC: Each channel has a synchronization signal SYNC. When asserted, this signal has the
• Compare RC Trigger: RC is implemented in each channel and can provide a trigger when the
TC_CCR.
same effect as a software trigger. The SYNC signals of all channels are asserted
simultaneously by writing TC_BCR (Block Control) with SYNC set.
counter value matches the RC value if CPCTRG is set in TC_CMR.
AT91M5880A
167