ADUC7020 Analog Devices, ADUC7020 Datasheet - Page 36
![no-image](/images/manufacturer_photos/0/0/56/analog_devices_sml.jpg)
ADUC7020
Manufacturer Part Number
ADUC7020
Description
Manufacturer
Analog Devices
Datasheet
1.ADUC7029.pdf
(96 pages)
Specifications of ADUC7020
Mcu Core
ARM7 TDMI
Mcu Speed (mips)
40
Sram (bytes)
8192Bytes
Gpio Pins
14
Adc # Channels
5
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ADUC7020BCPZ62
Manufacturer:
ADI
Quantity:
717
Part Number:
ADUC7020BCPZ62
Manufacturer:
ADI/亚德诺
Quantity:
20 000
Company:
Part Number:
ADUC7020BCPZ62I
Manufacturer:
ADI
Quantity:
15
Company:
Part Number:
ADUC7020BCPZ62I
Manufacturer:
ADI
Quantity:
1 500
Company:
Part Number:
ADUC7020BCPZ62I
Manufacturer:
ADI
Quantity:
298
Part Number:
ADUC7020BCPZ62I
Manufacturer:
ADI/亚德诺
Quantity:
20 000
Part Number:
ADUC7020BCPZ62I-RL
Manufacturer:
ADI/亚德诺
Quantity:
20 000
ADuC7019/20/21/22/24/25/26/27/28/29
•
•
INTERRUPT LATENCY
The worst-case latency for a fast interrupt request (FIQ)
consists of the following:
•
•
•
•
DDI0029G, ARM7TDMI Technical Reference Manual
DDI-0100, ARM Architecture Reference Manual
The longest time the request can take to pass through the
synchronizer
The time for the longest instruction to complete (the
longest instruction is an LDM) that loads all the registers
including the PC
The time for the data abort entry
The time for FIQ entry
Rev. D | Page 36 of 96
At the end of this time, the ARM7TDMI executes the instruc-
tion at 0x1C (FIQ interrupt vector address). The maximum
total time is 50 processor cycles, which is just under 1.2 μs in a
system using a continuous 41.78 MHz processor clock.
The maximum interrupt request (IRQ) latency calculation is
similar but must allow for the fact that FIQ has higher priority
and may delay entry into the IRQ handling routine for an
arbitrary length of time. This time can be reduced to 42 cycles if
the LDM command is not used. Some compilers have an option
to compile without using this command. Another option is to run
the part in thumb mode where the time is reduced to 22 cycles.
The minimum latency for FIQ or IRQ interrupts is a total of
five cycles, which consist of the shortest time the request can
take through the synchronizer plus the time to enter the
exception mode.
Note that the ARM7TDMI always runs in ARM (32-bit) mode
when in privileged modes, for example, when executing
interrupt service routines.