FAN7930C Fairchild Semiconductor, FAN7930C Datasheet - Page 17

no-image

FAN7930C

Manufacturer Part Number
FAN7930C
Description
The FAN7930C is an active power factor correction (PFC) controller for boost PFC applications that operate in critical conduction mode (CRM)
Manufacturer
Fairchild Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
FAN7930C
Manufacturer:
F
Quantity:
20 000
Part Number:
FAN7930CMX
Manufacturer:
FSC
Quantity:
1 900
Part Number:
FAN7930CMX
Manufacturer:
FAIRCHILD/仙童
Quantity:
20 000
Part Number:
FAN7930CMX-G
Manufacturer:
ON/安森美
Quantity:
20 000
Part Number:
FAN7930CMX-G
0
Company:
Part Number:
FAN7930CMX-G
Quantity:
4 500
© 2010 Fairchild Semiconductor Corporation
FAN7930C • Rev. 1.0.1
PCB Layout Guide
PFC block normally handles high switching current and
the voltage low energy signal path can be affected by
the high energy path. Cautious PCB layout is mandatory
for stable operation.
1.
2.
3.
4.
The gate drive path should be as short as possible.
The closed-loop that runs from the gate driver,
MOSFET gate, and MOSFET source to ground of
PFC controller should be as close as possible. This
is also crossing point between power ground and
signal ground. Power ground path from the bridge
diode to the output bulk capacitor should be short
and wide. The sharing position between power
ground and signal ground should be only at one
position to avoid ground loop noise. Signal path of
PFC controller should be short and wide for
external components to contact.
PFC output voltage sensing resistor is normally
high to reduce current consumption. This path can
be affected by external noise. To reduce noise
potential at the INV pin, a shorter path for output
sensing is recommended. If a shorter path is not
possible, place some dividing resistors between
PFC output and the INV pin — closer to the INV pin
is better. Relative high voltage close to the INV pin
can be helpful.
ZCD path is recommended close to auxiliary
winding from boost inductor and to the ZCD pin. If
that is difficult, place a small capacitor (below 50pF)
to reduce noise.
The switching current sense path should not share
with another path to avoid interference. Some
additional components may be needed to reduce
the noise level applied to the CS pin.
17
5.
A stabilizing capacitor for V
close as possible to the V
difficult, place the SMD capacitor as close to the
corresponding pins as possible.
Figure 44.
Recommended PCB Layout
CC
CC
and ground pins. If it is
is recommended as
www.fairchildsemi.com

Related parts for FAN7930C