S1D13742 Epson, S1D13742 Datasheet - Page 131

• Manufacturer Part Number: S1D13742
• Description: Mobile Graphics Engine
• Manufacturer: Epson

Epson Research and Development
Vancouver Design Center
X63A-A-001-06
X63A-A-001-06
X63A-A-001-05
X63A-A-001-05
Hardware Functional Specification
Issue Date: 2007/09/18
Revision 6.01 - Issued: 2007/09/18
• all changes from the last revision of the spec are highlighted in Red
• section 5.1, for the Intel 80 Data Pin Mapping tables, swapped the MD[15:8] descrip-
• section 7.3.1 ~ 7.3.2, added note and clarified the usage of MD[15:8] pins in the Host
• section 17.1.3, updated the X/Y Start/End data order in the Sequential Memory Write
• section 22, added References
• section 23, added Sales and Technical Support addresses
Revision 6.0 (Issued 2007/05/29)
• all changes from the last revision of the spec are highlighted in Red
• section 14 Gamma Correction Look-Up Table Architecture - correct typos in Figure 14 -
• section 19.1.3 S1D13742 Register Settings for 800x480 TFT Panel - correct typo in
Revision 5.02 (Issued 2006/08/23)
• all changes from the last revision of the spec are highlighted in Red
• globally add QFP20 144-pin package information
• section 5.3 LCD Interface Data Pins - correct typos in table, change Hi-Z to Driven Low
• section 6.3 Electrical Characteristics - add table 6-5 Electrical Characteristics for
• section 7.2 RESET# Timing - add CLKI signal to figure
• section 7.3.1 Intel 80 Interface Timing - 1.8 Volt - rewrite section for 1.8 volts
• section 7.3.2 Intel 80 Interface Timing - 3.3 Volt - add this section
• REG[2Ah] bits 4-0 - add note “RGB 6:6:6 mode 2 and RGB 8:8:8 mode 2...”
Revision 5.01 (Issued 2006/04/28)
• updated EPSON tagline
• all changes from the last revision of the spec are highlighted in Red
• section 4.2.1 Intel 80 Host Interface - for MD[15:0] rewrite the note in pin description,
• section 4.2.2 LCD Interface - for VD[35:0] rewrite both notes in pin description
tions for CNF1=0, B00 should be “internal resistors” and B01 should be “Hi-Z”
Timing figures and tables
Example Sequence figure and moved it to section 17.1.3
1; change data from display buffers to 6 bit, change the multiplexers to 64 positions
from 256
Table 19-3, change the REG[04h] value to 0Bh
IOVDD or PIOVDD = 3.3V ± 0.3V
for GPIO_INT add reference to General Purpose IO Pins Registers to pin description.
Revision 6.01 - EPSON CONFIDENTIAL
Change Record
www.DataSheet.co.kr
X63A-A-001-06
S1D13742
Page 131
Datasheet pdf - http://www.DataSheet4U.net/