MT9M019 Aptina Imaging Corporation, MT9M019 Datasheet - Page 8

• Manufacturer Part Number: MT9M019
• Description: 1/5-Inch 1.3Mp CMOS Digital Image Sensor
• Manufacturer: Aptina Imaging Corporation

Signal Descriptions
Table 3:
Output Data Format
CCP2 Serial Pixel Data Interface
PDF: 7723845879/Source:2828556980
MT9M019 DS - Rev. F 5/10 EN
V
D
V
AA
GND
VAAPIX1, VAAPIX2
DD
1, V
(XSHUTDOWN)
A
A
1, V
GND
GND
1, D
Pad Name
RESET_N
DATA_N
GPI[1:0]
DATA_P
AA
EXTCLK
V
CLK_N
FLASH
CLK_P
S
DD
SCLK
TEST
1, A
DD
DATA
2, V
3, A
GND
2, V
PLL
Signal Descriptions
GND
AA
GND
2, D
DD
3, V
2,
4
GND
CCP
AA
3
4
Table 3 provides signal descriptions for MT9M019 die. For pad location and aperture
information, refer to the MT9M019 die data sheet.
The MT9M019 serial pixel data interface implements data/clock and data/strobe signal-
ling in accordance with the CCP2 specification. The RAW8 and RAW10 image data
formats are supported.
Pad Type
Output
Output
Output
Output
Output
Supply
Supply
Supply
Supply
Supply
Supply
Input
Input
Input
Input
Input
I/O
Master clock input. PLL input clock. 6–27 MHz.
Asynchronous active LOW reset. When asserted, data output stops and all internal registers
are restored to their factory default settings.
Serial clock for access to control and status registers.
General purpose inputs. After reset, these pads are powered-down by default; this means
that it is not necessary to bond to these pads. Any of these pads can be configured to provide
hardware control of the standby and S
Enable manufacturing test modes. Wire to digital GND for functional operation.
Serial data for reads from and writes to control and status registers.
Differential CCP2 (sub-LVDS) serial data (positive).
Differential CCP2 (sub-LVDS) serial data (negative).
Differential CCP2 (sub-LVDS) serial clock/strobe (positive).
Differential CCP2 (sub-LVDS) serial clock/strobe (negative).
Flash output. Synchronization pulse for external light source.
Analog power supply.
Analog power supply for the pixel array.
Analog ground.
Digital power supply.
Common ground for digital and I/O.
PLL power supply.
8
MT9M019: 1/5-Inch 1.3Mp CMOS Digital Image Sensor
ADDR
Description
functions.
Aptina reserves the right to change products or specifications without notice.
©2006 Aptina Imaging Corporation. All rights reserved.
Signal Descriptions
www.DataSheet4U.com