xr17v254 Exar Corporation, xr17v254 Datasheet - Page 39

• Manufacturer Part Number: xr17v254
• Description: 66mhz Pci Bus Quad Uart With Power Management Support
• Manufacturer: Exar Corporation

REV. 1.0.0
The receiver section contains an 8-bit Receive Shift Register (RSR) and Receive Holding Register (RHR). The
RSR uses the 16X or 8X clock for timing. It verifies and validates every bit on the incoming character in the
middle of each data bit. On the falling edge of a start or false start bit, an internal receiver counter starts
counting at the 16X or 8X clock rate. After 8 or 4 clocks the start bit period should be at the center of the start
bit. At this time the start bit is sampled and if it is still a logic 0 it is validated. Evaluating the start bit in this
manner prevents the receiver from assembling a false character. The rest of the data bits and stop bits are
sampled and validated in this same manner to prevent false framing. If there were any error(s), they are
reported in the LSR register bits [4:1]. Upon unloading the receive data byte from RHR, the receive FIFO
pointer is bumped and the error flags are immediately updated to reflect the status of the data byte in RHR
register. RHR can generate a receive data ready interrupt upon receiving a character or delay until it reaches
the FIFO trigger level. Furthermore, data delivery to the host is guaranteed by a receive data ready time-out
function when receive data does not reach the receive FIFO trigger level. This time-out delay is 4 word lengths
as defined by LCR[1:0] plus 12 bits time. The RHR interrupt is enabled by IER bit [0].
4.7
4.7.1
F
IGURE
Receiver
Receiver Operation in non-FIFO Mode
(8XMODE Register)
and Errors
Data Byte
16X or 8X Clock
17. R
Receive
ECEIVER
O
PERATION IN NON
LSR bits
Flags in
Error
66MHZ PCI BUS QUAD UART WITH POWER MANAGEMENT SUPPORT
4:2
Receive Data Shift
Register (RSR)
Holding Register
Receive Data
-FIFO M
(RHR)
39
ODE
Validation
Data Bit
RHR Interrupt (ISR bit-2)
Receive Data Characters
RXFIFO1
XR17V254