h8s-2169 Renesas Electronics Corporation., h8s-2169 Datasheet - Page 152

• Manufacturer Part Number: h8s-2169
• Description: Renesas 16-bit Single-chip Microcomputer H8s Family/h8s/2100 Series
• Manufacturer: Renesas Electronics Corporation.

Section 5 Interrupt Controller
5.5
5.5.1
Interrupt operations in the H8S/2169 or H8S/2149 differ depending on the interrupt control mode.
NMI and address break interrupts are accepted at all times except in the reset state and the
hardware standby state. In the case of IRQ interrupts and on-chip supporting module interrupts, an
enable bit is provided for each interrupt. Clearing an enable bit to 0 disables the corresponding
interrupt request. Interrupt sources for which the enable bits are set to 1 are controlled by the
interrupt controller.
Table 5.5 shows the interrupt control modes.
The interrupt controller performs interrupt control according to the interrupt control mode set by
the INTM1 and INTM0 bits in SYSCR, the priorities set in ICR, and the masking state indicated
by the I and UI bits in the CPU’s CCR.
Table 5.5
Figure 5.7 shows a block diagram of the priority decision circuit.
Rev. 3.00 Jan 18, 2006 page 124 of 1044
REJ09B0280-0300
Interrupt
Control Mode INTM1 INTM0
0
1
Interrupt Operation
Interrupt Control Modes and Interrupt Operation
Interrupt Control Modes
0
SYSCR
0
1
Priority Setting
Register
ICR
ICR
Interrupt
Mask Bits Description
I
I, UI
Interrupt mask control is
performed by the I bit
Priority can be set with ICR
3-level interrupt mask control
is performed by the I and UI
bits
Priority can be set with ICR